Recent content by Blomie

I removed the lokka the other day so i could send it back for them to inspect. funnily enough when i removed it one of the spacers was broken it had a chunk missing from that same lip you are grinding in your picture. also one set of the cam gears were badly worn and could possibly be the...

I've got that exact tool :) the bearings are all good, ive set them properly and even made sure it was all in spec with the correct wheel weight preload,

I actually had the diff centre entirely out of my cruiser and on my shed floor when i installed it :) my spacer clearance was 0.006 on both sides of the cross shaft pin which is dead on what the manufacturer recommends and my cam gap was 0.156 which is right in the middle of the clearances...

Arp do a chromoly stud upgrade, that's what I've got and they seem pretty good so far you can get them from Locktup Fabrication, Hardcore Offroad Parts & Accessories these are the ones I have ARP Hub Stud Upgrade [TOY-ARPHS-KIT] - $69.00 : Locktup Fabrication, Hardcore Offroad Parts &...

hey guys I'm still having trouble with this lokka. As you know I've been breaking pins and axle studs. To fix the problem I have removed the lokka replaced the springs and pins, checked and ensured all clearances are within tolerance(I have photos of all the clearances) replaced all my axle...

and more pics :)

here are the pics of my lokka install, after a little playing aroud with the thrust washers I got the tolerances pretty much perfect

These are the burrs I was talking about. I replaced the wheel bearings in the hub right before this happened so I'm not too keen on replacing the hub, I'll have a go at grinding/filing/sanding them flat first

I've found two possible causes so far. on my hub there seems to be a slight burr where the dowels have broken and slightly elongated the hole which would cause less friction between the axle flange and the hub causing the studs to take alot more stress than usual. on inspection of my lokka...

Hey everyone I've had a lokka installed in my front diff for a few years now with no problems and I've given it a fair bit of punishment. I recently installed another lokka in the rear of my hj61 in a good diff centre. while installing it I replaced my wheel bearings on both sides and checked...

parting out my fj62 nearly everything is there. has aircon and all power options front half of interior is in good condition gearbox and transfer case is in good condition anything you need just let me know :) parts already gone are -front bar -power steering

parting out my fj62 nearly everything is there. has aircon and all power options front half of interior is in good condition gearbox and transfer case is in good condition anything you need just let me know :) parts already gone are -front bar -power steering