Hummm... I want to go but don't have sliders on my GX yet. I' don't mind if the stock steps get banged up, but don't want door frame damage either. Know any local bolt-on sliders that I can get before then?
I honestly wouldn't mind just going back out to DDR this weekend. I have the gia maps and we can explore a bit too. Maybe keeping it low key... packing a lunch and just hitting the trails.
Down for both! I may have to ride with someone for the 9/19 trip - still don't have skids on the GX -_- Competing priorities... house or skids ¯\_(ツ)_/¯
Let me preface this by saying that I don't have direct experience with CA inspections. The SAP only runs for a few seconds on cold start. So, unless the smog test includes a cold-start test, it will pass just fine.
Don't need to worry about having to take off the manifold. The bypass kit simply clicks into the air intake's existing wiring. The installation of the block-off plates are a bit more involved. To do that you have to dismount the front tires so you can get in back behind the engine to where...
Count us in!
What do y'all think about meeting the Marathon gas station off I24 just north of Nashville? 7534 Old Hickory Blvd, Whites Creek, TN 37189,
Also, what time? I'm a morning person, so early is fine for me!
Just so you know, there is no wire cutting with the new Hewitt kits. You do have to wrap the wire around one of the starter relay posts, but thats super easy. The block-off plates aren't too hard if you flood the Hewitt instructions. All that being said, since you're doing the preventatively...
I went with Hewitt Tech. Their new kit comes with a starter wire, no cutting required. Can also order with the conduit to run the wire so it looks professional. The instructions are spot on.