Yes - I have them all round on my 100 series. Tried 2 sets of OEMs - both lasted about 18 months before warping on the fronts. So I put on DBA 4000 series. Plus I run pads from DBA.
They're so good I have them on the front on my 150 series. That came with warped discs but the dealer put...
Does anyone know the brake refurb kit for a front caliper set ? 2016 150 Toyota. They are 4 pot calipers - replacement part # is 47750-60350
I want the refurb kit but cannot even find out the piston size so I can buy a generic kit
TIA
I'm currently in TPMS hell also - I had one bad sensor but I'm predicting more (hence justifying to myself the cost of the diagnoistic tool)
I simply coded the new sensor to the dead one's ID. Next step is finding a dry day to install into the tyre!
I got both batteries charged - the CTeck charger failed to charge one of the 2 batteries which is why it appeared dead. It does that sometimes so I also have a cheap as chips ebay charger which is only 6 amps but gets the job done when the more expensive one doesn't
WIth both batteries fully...
yes it starts - but I guess it depends on what totally dead means? I'll isolate the batteries and test them individually - something odd is going on
I'm not convinced the starter is 24v - Rough Trax lists the replacement as 12v
A Brand New premium 120 amp 12V diesel alternator for the Land...
My UK spec factory battery question. Looking for input.
My 100 has factory twin left/right battery setup and 3 years ago I had new batteries installed.
The one on the drivers side will take charge, however when I put the Ctek on the left hand (passenger side) battery it looks to all...
I just wanted to add one point here that I haven't seen mentioned about indexing
I have just finished fitting Iron Man shocks. torsion bars and standard springs (I didn't want a lift)
100 is sitting right now at
Front right 49cm or 19.3 inches
Front left 49cm or 19.3 inches
Rear right 57cm or...
Hi
yes - it is beat on.
I had to cut out the torsion bars - they were rusted to the cups and no amount of work could get them out whilst under the car. They had been repeatedly doused with Deep Creep and WD 40 penetrating fluid.
It took 20 mins of blowtorch and hammer to get the old bars out...
It's fouling bolt 2 - I have pushed the cup up as far so that the splines disappear into the cup - further than the old bar was.
The old bar was 120.6 cm and the IronMan one is 121cm. It's that 4mm that's the problem. I'll try again whaling on the cup pushing it up the bar with a hammer and...
yes thanks - the splines are fully engaged/pushed in on both ends of the bar. All mounts are cleaned and greased - so are the splines on the torsion bar. I am going to have to get a tape measure and measure the length of the bar + mounts and the available space to manoeuvre it into place (inc...