Recent content by BillyBaroo

Thx. yah it would seem so—but i can’t seem to dial in on it. my local mechanic is head scratching at the moment as well. back up on the rack today. I’ll report back if we find it! thx again for input

I’m trying to track down a strange rhythmic clicking/tapping noise on my 2011 GX460 (approximately 182K miles). The sound is most noticeable around 20–25 mph. It speeds up as vehicle speed increases, almost like a boxing speed bag or a playing card hitting bicycle spokes. Interestingly, it...

thx. ordering now!

where can I purchase that? thx

I found some end rails that fit from Mcgeorge Toyota Online Parts

So--I purchased this custom made rack for my Boy-- and I now have to wire the led lights with relay. I'm clueless and looking for best practice to get wire through firewall and connect with relay to power. I'm having a difficult time finding any detailed similar efforts? Does anyone know where I...

anyone know a good spot to find end rail cap for ‘04 LC? I’ve ordered two now from two different sites that say they’ll fit but alas they do not! Thx for any help… b.

Just wanted to leave an update. Found the leak was coming in at the top left of passenger windshield. Initially I tried to use flowable silicon for windshields—but water was still finding its way in. so i scraped as much as i could out and decided to try a different approach. I’ll put some pix...

hey . yah—-i tested again just now to be sure. i ran a weed eater chord down both sides. i think it might be originating at the top corner of passenger side—like right above the vanity mirror. just need to figure out how to seal that (ie if it’s above the glass on roof side or in front side of...

yes. thx for clarifying question. i tested the sunroof and cleared out the gutters on both sides and no leaks . i believe it’s coming in somewhere between the front most post of the roof rack and the top corner (& maybe 8 inches in on the top of the windshield. then i think it’s finding it’s way...

hi there. well, i pulled it back to apply trim adhesive as some was pulled back—but i noticed it was pretty warped and lumpy all the way down where it covers the rivets. Also notice a two inch gap at the top which i assumed was by design. i tried putting the flowable silicon over it all to try...

so i’ve read all the leakage i could find on here. but i’m still dealing with mystery and looking for best fix. testing so far using painters tape and a hose suggest the leak is somewhere around the top corner of passenger side windshield. after putting hose or glass of water on it water finds...

So, my Cats are both bad (as per local mechanic after checking codes and doing some digging) The truck is running fine at the moment--but I will want to replace soon. Just curious to know which route you went and how it turned out? Lessons learned appreciated...Thx

Thx awesomeissquid! I’m an idiot —I didn’t even realize there was a button for the antennae. problem solved. thx again mate!

Mauser! Fusible link for the win!! they said the cause was from the battery being installed backwards?! At any rate—Oreillys said they would pay the bill and all is back to. penal except my antenna will only go up a few inches. But all in all a win! Thx again for your input—hope someone else...