Recent content by bigtex760

Mine has been broke for years now with no problems. I have not been where its really cold only in the 30's but it starts fine.

Osidetiger has the injectors. the also supplied m e with the adpators.

Oside tiger has injectors. I've purchased 4 set from them for my cruiser as well as 3 of my customers.

Seems reasonable to me.

Typically a miss under load is a secondary ignition problem-Spark plug wires, dist cap or rotor.

Old town upholstery in Escondido, pricing is very fair, He's not the cheapest and not the most expensive and does very good work. They do a lot of work for me and my customers. I have talked to Eric (the owner) about install my heat warmers as well. Once I have some down time with the truck he...

No you cannot. I did not want to buy new cats without know it would make a difference. Now that i know my old cats were part of the problem i will install new cats. I do not think new cats will hurt the power just old partially clogged cats did hurt the power and MPG's.

The mileage went up slightly about .75-1.25

That was my first experience with lack of power, going to big bear (6700ft) as I started to climb I was dropping speed quicker than a semi lol. I had a fresh tune up and complete baseline before this trip. Since then I've installed upgraded injectors, advance timing to 12 degrees, removed the...

I've install the upgraded injectors on a 3fe and a 1fv. Both had better idle quality and smoother acceleration. Part throttle is a big difference, wide open throttle not such of a difference but still better. Both these vehicle had over 200k on them so maybe just getting new injectors help? I...

Installed a snorkel. What a difference getting air to the engine makes. Part throttle is a big difference, wide open throttle little change. Also almost finish installing the northwest trails weld it yourself rear bumper with tire swing.

At what coolant temp should the switch do something? I'm assuming it just riches up the fuel trim correct?

I also broke mine and have not replaced it in a few months. I have not noticed a difference, please let me know what you find out.

You pressure test a system to find a leak, thats what the test is for.

You need to pressure test the system, it will save you a ton of work.