Anyone know if i a brass npt cap from home depot will fit to cap the rear lines until i can replace? Does anyone know the size of these?
Also, why cant i just unscrew the line at this junction and cap it? My leak is where everyone elses is just above this junction at the clamp.
Yea i did mark the rotor but when i put my timing light on it, i was off and advanced 15 degrees. Small adjustment with the timing light and i was back on target at 3° advanced timing which is where the factory set out timing. Im sure youre fine but may be worth putting a timing light on it to...
Looks like i have to take the fan and shroud and everything off to set the harmonic balancer to tdc in order to change this O ring on the distributor? Please tell me theres a better way. No way you're getting a 30m socket on that harmonic balancer bolt and a breaker bar to turn the motor over...
I just talked to the guy Alex and he said if I ordered today, the bumper is 3 weeks out. He asked that I pay cash via zelle or venmo to keep from paying taxes. I'm a little worried about the fact AOE went dark for a couple years, Alex says due to his medical issues, but no website now and seems...
Had a tree limb fall on the 80 and caused some damage. I had everything repaired but i cant find the side mirror piece that goes on top of this piece where the glass mounts to. Hoping someone may have a junk side mirror laying around that i can buy or just buy the glass piece. This is the...
Looking for the belt moulding trim for my 97 80 series. This is the trim that lines the top of the doors meeting the bottom of the windows. Mine are delaminating and I'd like to replace them. New they are pretty pricey.
How hard would it be to convert this to CAD? If it's something easily done I would love to have it in CAD. My brother is the CAD guy but did tell me it would be great to have it in CAD rather than PDF