Recent content by Betterlate222

  1. B

    2001 LX470 Steering Rack replacement

    I looked at that and thought I'd end up breaking it so went back and lifted another 3/4 inch to clear the R/P. It worked but now I know!
  2. B

    Steering Flush & Cleaning

    Thank you for your time and help! I'll add replacing the diff seals to the list as I'm replacing the FDS (CVs). Unfortunately I've already pulled and blue locked the tensioner bolt. Hoping that won't bite me later. I honestly didn't consider the FIPG as a bolt sealer but that makes sense...
  3. B

    Caked on oil in the front of the block. From a seal or maybe the oil pan?

    Update. I stumbled across another thread discussing that oil pan. One of the top posters (2001LC) wrote about the known leaks around the hyd belt tensioner. I thought right! I noticed a lot of old oil in that area but didn't see that as the culprit. I went back under and see that now as the...
  4. B

    Steering Flush & Cleaning

    Thank you for all the information you provided! Really helpful. I'm in the process of replacing the reservoir, hoses, pump,, piping and R/P on my LX. The old reservoir hoses leaked for an unknown period. I have the CV's and hubs off. I'm guessing I need to replace the RH bearings and seals...
  5. B

    Caked on oil in the front of the block. From a seal or maybe the oil pan?

    The car is still in pieces. I'm waiting for an OEM air manifold gasket after replacing the starter. The T-belt project is half done. I didn't put all the parts back as I wanted that space open when replacing the rack. I have good access of the pan now that the motor is lifted an inch and the...
  6. B

    Caked on oil in the front of the block. From a seal or maybe the oil pan?

    Thanks for the reply. I took another look and don't see a dent. I also looked at the frame and cross members. Nothing that would make me think it was hit. Maybe it's the way the pic was taken.
  7. B

    2001 LX470 Steering Rack replacement

    Thanks Steve. I had already elected to buy the replacement parts (hoses, pump etc) while I'm doing the T-belt and CV's. I did jack up the motor but found that blasted drain funnel below the oil filter in the way. Ended up going maybe 1.5 inches. Also it's important to note I still have the...
  8. B

    Caked on oil in the front of the block. From a seal or maybe the oil pan?

    Hello group. I recently removed the old steering rack and found a thick layer of old caked on oil in the front of the block. I just replaced the timing belt but did not replace the seal. I'm not sure if this oil came from the seal or perhaps the oil pan gasket? I just replaced the starter...
  9. B

    Steering Rack Replacement Questions

    Hello, I'm in need some help with my 2001 LX470. I posted a question yesterday on the steering wheel locking points and haven't got a response yet. I'm sort of stuck until I have a little help. My question is before I start removing the bolts holding the rack down and even before marking I...
  10. B

    2001 LX470 Steering Rack replacement

    Hello group. First post. I'm in the middle of a series of replacements on my LX. Started with the starter and as I'm sure you all experience, bloomed into a longer list of "while I'm at it's". My steering has been terrible since I bought it. Grinding and stiff. While working on the...
Back
Top Bottom