Recent content by BakerFJ

Ironically just did a Mud search to see if it's anywhere, and sifted through his profile but didn't see anything, although maybe it's hiding? haha

Found this 80-series frame scan-- 468.51 SEK ($44.39) on Etsy. https://www.etsy.com/listing/1643169436/toyota-80-series-landcruiser-chassis-3d Haven't purchased it yet as I have the dimensioned frame blueprints that are floating around 'Mud. But when I get to designing sliders, will likely be...

I think about $350-400 from the local junkyard. They originally wanted more because they're airbag seats but the guy gave me a Christmas deal

Definitely gutter rails -- If possible the full roof width. Inner quarter panels (without trim pieces) Headlight housing And quarter window, if it hasn't been done yet! If you get around to them, a big thanks in advance. :cheers: One of these days I'll cough up the cheddar for my own 3D scanner

CAD isn't too bad to figure out. It's mostly just drawing lines and shapes, and setting dimensions. I use Autodesk Inventor for most things honestly (even though I have much more advanced CAD programs at my disposal). Once you have a flat 3D part, you can export the face and have a 3rd party...

Captain's seats, heated, and all the adjustments including bolster! Not gonna hear me complaining;)

Any updates? Planning on tackling ABS door cards soon. What are the chances of you would share your CAD files so this engineering student can make some magic happen? :cheers:

Unsure if you figured your issue out, but my code 12 ended up being an issue with the hall effect sensor internal to the distributor. There's no electrical test for this outlined in the FSM although if you're handy with signal reading I suppose you could. But it basically comes down to the air...

I've been experiencing code 12 as well, though I don't have a dual battery set up. All the distributor wiring to the ECM ohms out fine, I have also tested the distributor itself and swapped ECMs. This points me to the distributor being the problem child, however being that the distributor tests...

any update to this? having a similar issue with hot/cold temps

Did you end up finding the issue?

2012 Range Rover Sport HSE (L320) seats. Tons of adjustability, and heated. Both seats have lumbar and driver seat has bolster as well. I am 6 ft tall for reference, pant length 32. EDIT: This is a link to a Google Drive folder which contains a PDF outline which contains the wiring diagrams I...

Installed power seats from a 2012 Range Rover Sport and gave my interior a full detail (after 7 years of ownership🤣). This seat swap hasn't been done yet and there were complexities to bypass the CAN Bus, but I'll be making a full write up with all the necessary info to make it straightforward...

Has anyone done tubular flares like a lot of Wranglers have? Probably gonna custom fab my own set at some point

Every year for Halloween, me and a handful of Toyota friends go offroading/camping for the weekend. This year was our first time going to General Sam's Offroad Park which is near Houston, TX. Super muddy, given that it had rained a ton leading up to the trip. I believe we were the only Toyotas...