Recent content by Bagheera

  1. Bagheera

    Electric FJ40

    I'm in South East Alaska, it barely ever freezes here (Average winter temperature of 36F) and the car is usually parked inside a heated garage. I'm looking at 144V motors with a torque of about 250 ft-lbs at very low RPM. I only need a 30 mile range (we do not have more road here) and topspeed...
  2. Bagheera

    Electric FJ40

    I totally agree that savings on money should not be the reason to do a conversion, but it greatly depends on where you live and how you use your rig if you can have any savings or not. Here in Sitka the difference is about 40ct a mile between gas and electric. If I do a low end conversion (used...
  3. Bagheera

    Electric FJ40

    13 years later. i'm considering it for my upcoming FJ60 restoration and have done a lot of research. Technically it is not difficult, it is not cheap. So I'm now weighing the cost/benefit ratio. There is a mining company in Australia that converted a bunch of older LC's to electric. Their...
  4. Bagheera

    Sticky brake pads

    The problem is solved now so I wanted to give you guys feedback as to the solution that did the job. First i tried the easy way and just lubricate the sliding hardware. It did help but not sufficiently. So I did opt to replace the MC and now they work like a charm. I still got some stubborn air...
  5. Bagheera

    What do foreign cruisers look like?

    I think the tailgate is absolutely awesome and it is one of the reasons to have bought a LC. It is perfect for lumber hauling!
  6. Bagheera

    What do foreign cruisers look like?

    I'm originally from the Netherlands and we use the Dutch language. Anything I have ever seen printed on any car of any vintage is in English, including Toyota's. I assume that the Landcruiser is no different there.
  7. Bagheera

    Sticky brake pads

    Under the hood does look a lot better indeed, but I do not have good results with "easily" removing things from this car. Is there a change in design with the newer ones that this is not required anymore? Not that bench bleeding is that big of a deal, but he, all bits of time saving helps...
  8. Bagheera

    Sticky brake pads

    Thank you for the tip. The problem is that my brake system (and other systems too) has so much rust that I will have a hell of a time to just disconnect it. What would have been a normal 1 day job on caliper, rotor, shoes and drum replacement turned into a 3,5 day ordeal because of all the rust...
  9. Bagheera

    Sticky brake pads

    Yes the calipers did slide on very easy, no resistance at all. I suspect that the master cylinder is still the original one. It is on the list to be replaced, but I was hoping to postpone that until i do the complete re-built.
  10. Bagheera

    Sticky brake pads

    I got them from cruiser Corp (Oklahoma) as well as the pads. When they were laying on the workbench they slid easily. Do you folks generally lubricate the surfaces where the pads touch the sliding hardware? They do release, but it does take way to long and both sides pretty much equally.
  11. Bagheera

    Sticky brake pads

    hello all, I'm fairly new here (though have been lurking for a while) and I have a issue with newly replaced brakes. I have been searching for the last couple of hours on this forum, but have not been able to find an answer or any suggestions as to what it might be. I have an 1986 FJ60 which...
  12. Bagheera

    Registry 60-series Registry

    1. 1987 FJ60 with 2F engine and 4 gear. 2. Erik. 3. Mr.T. 4. 168.000. 5. A very crappy granny catcher on the front. 6. Daily driver. Heavy hauler for lumber, metal, equipment and tools, occasionally we use the rig to pull a tree over when it has to come down. I live in Alaska and we have only 20...
Back
Top Bottom