Recent content by AZ80

Bump motor/tranny ready to ship

623-202-7108 Text this guy Adrian, used him a few years ago. Don't know today's pricing, but atleast it's another quote for you.

Key on I'm getting this resistance from my maf ground wire. Key off its 0. Is this normal?

No stored codes, that's the only pending code. Truck shifts through all gears

LQ4 /4L80e Code P0102 low voltage maf sensor I have ground,12v, 5v. Across 3 Maf sensors,1 that is new. Cleaned TB front and back. New tps and iac. Have not found any vac leaks and tried 2 different intake set ups. Idle is 650, surges/lowers when put in reverse. Hesitation/bogs if I throttle to...

Cool beats coordinating a shipment

She's ready to ship. Details in 1st post

Ground wire at the back of engine ! 🥲 She purrsss

Any other ideas why injectors wouldn't fire?

👍

But the noid light wasn't lighting up either. Going to take ecu back to tuner just to be sure.

Only starts with starting fluid. I dont see injectors firing while cranking

Noid light went off only a couple flashes then never again... I'm thinking vats as well?

Tested both ways. 11v only when relay is disconnected. It fires up for a sec with starting fluid. Going to run and get a fuel pressure tester and tuner will stop by to verify vats delete soon.

Pin 9 11v when not connected to relay and key in ON position