Recent content by Argilb852

HKS from Japan has a supercharger kit for 1UR, I think you can have a look. They claim no need for any cutting or permanently modification.

Thank you for your help, will find a leveled ground and try to fix the KDSS.

Hi all, just having a new spring installed with 40mm lifted. So the right hand side of the vehicle is lower than the left hand side now because of the KDSS lean. My concern is, should I do the wheel alignment first, or fixing the KDSS leveling first? Is there any different for doing any one...

I'm using 15w50 in Hong Kong, obviously the engine is less heat. (But my engine is 1UR-FE, 4.6 V8)

I also have same issue, but my 200 is still working well. Even my old prado(1999) have same issue, also working good.

hey ching, you can buy parts from japan directly, no need to worry about VX or VXR. Japan have ZX/AXG/AX and GX, not VX or VXR

I've got similar problem on the servo, just order a new servo and replace it later(DIY). There have 8 servo in the air con system, hope I can find the correct one. My problem is the driver side don't have cold air, and rear outlet only have hot wind. Before the problem show up, the servo have...

I also have this problem, after using the OEM spacer, the outer shoulder will quickly worn out. I check the alignment, but the data are very 'perfect'. after all I found out that the tire pressure is not enough, and the tire are running in flat sharp, so the shoulder worn out easily. *I'm using...

I think the point is 43136-60020 is OEM parts in LC200 , so it would not have big problems on working with other parts? btw I remember the OEM spacer is like steel more than aluminum, I brought pair of them before and installed on my LC200 because factory just missing it.(for model before 2015...

Hi everyone, I'm using Koni 88 Heavy track for year with OEM height and spring. Just thinking to use jaos spring for lifting The jaos springs is suitable for raise up 35-40mm(front) and 30-35mm(rear) but the koni 88 HT is only allow 0-30mm for front and rear. Is it possible for this matching? I...