Recent content by antFJ

for like 7K more you could have gotten a full body and top with paint! Now that would be a crazy unboxing

Here ya go. Horn Button for Land Cruiser FJ40 FJ45 FJ55 - https://www.cityracerllc.com/products/horn-button-for-land-cruiser-fj40-fj45-fj55

Recommend using the measurements in my thread with a long 72'' metal ruler/straight edge. A used top will be stretched and warped and isn't a good template. Just lay the fabric out in a very flat space and you can cut the pieces with a fabric pencil and a giant ruler. Get a bowl or other...

Sorry.... it has been way too many years since I did this. I have no idea anymore but I learned how to do it on this forum so the info is definitely in the FAQ somewhere

I found 20 bucks yesterday

If I remember correctly I would use really nice painters tape for the straight lines (two bottom V lines and then one long piece across the top. Then I would hand paint the white with a very small brush Then I use a razor blade or q tip or toothpick to clean up the inside paint lines or I...

Whoops! I've been away from the forum for too long. You are correct. You cannot use a EARLIER (horn button in center) with a LATER wheel (center is decorative only... horn buttons on the side). Note: there are multiple versions of the plastic insert for the EARLY horn button. Those plastic...

He's not talking about that kind

EDIT Not without some custom fabrication

just got my tires replaced the other day... haven't seen or driven my rig in years and I had to sit there and stare at the rear axles... I just couldn't believe that the nuts weren't fully engaged. I don't remember them being as bad as yours... but the studs weren't flush with the nut. Just...

I had a shop warp my cluster when they went to sandblast it and powder coat it... I honestly do not know at what step they messed up but the second shop got it right. Just a word of caution it is pretty thin metal

Nexen Roadian MT - #10667NXK Off Road Truck SUV Size: LT235/75R15 converted = 28.9'' x 9.3''

Hi guys, i haven't forgot about you and the horn buttons. I want to make more but it's going to be a long time before I figure out how to do it in a way where it doesn't take 5 hours per button. I think the metal retainer rings can be made as well with a simple press. Your best bet if you...

Hey Josh will do - this weekend okay?

Hello! Hope everyone has been doing well. I've been MIA from New England for almost 12 years! My land cruiser has been all over the United States and was shipped back to CT to storage two years ago while I've been overseas. I'm headed back to the US soon and I want to make sure the 40 is...