Recent content by Adrigan

Thanks, I measured them. The longer end is towards the front. Also the bumpstops line up with the axel.

YEah, I think so too. Let me measure them. Long side facing front?

The Yolk and Driveshaft splines. Splines are farther out.

Question for the group. My FJ40 is lifted 2.5 inches via leaf springs via a Pro-Comp kit. Now my issue is that my front driveshaft is loose. I can wiggle it back and forth by hand and feels like just the tip is in :) Unfortunately, I can't remember if it was this way before I did the lift, as I...

I just have to post a thank you to these threads. I spent about a month trying to figure out my brakes. Bleed a gallon of fluid. Burped the cylinders, new master, new booster. Finally took of hubs and found that one of my adjusters were stuck which I had to free. Once that got working I was...

Ok so I paid $1700 and got their top line job wuch was both paint and sealer. This included some body work on the hood and side door. Overall I'm happy with how it looks. The guy didn't try to sell me anything and If I had to do it I would do it again. Only thing I don't know is...how long will...

I wenntwith Brocton Should be done in 2 weeks.

FWIW I got a quote for $1700 for base and clearcoat. I'm going to do it and let you know how it goes.

Hey Eastern Yetti, Did you ever get it done? I'm debating Maaco or Doing it myself. I've done my hood myself and was happy with the result the issue is time and space.

I traced the source of my rough idle to my choke pull off 21609 pictured below. Anybody know where to get a replacement. I can't find it anywhere.

Anybody know where to purchase the choke pull off 21609 i the pic above? I isolated it as the source of my rough idle (it doens't hold vacuum) and I can't find a replacement

Would like to know also, truck is desmogged. new pump, checked booster and PCV for leaks....still problem

For reference. If it helps, I redid front end the first time in about a week. This was because thehub bolts were stuck and I had to get tools/make tools ETC. I had to rebuild one hub because I thought a peice of metal might be stuck in there. That only took me about 4 hours. Also don't mix...

I just noticed that this isn't too old of a post. I'm considering replacing my bushings as everytime I go over a speed bump my rear end sounds lilke i'm dropping metal (leafs look good, no cracks/sag) Would love to hear ride updates.

I down the cape this week and saw an older FJ40 beige (hatch door) cruise by me in Chatham. I wish I brought mine but I've yet to put a hitch on mine to carry all the bikes.