Hi all.
2008 at 186,000 miles. belt last replaced at 79,000.
A few weeks ago I had constant squealing of the belt which went away when I poured some water on it.
Took it to Toyota. They said that besides the belt, the tensioner and pulley “needed” to be done too to “guarantee” the noise...
Thanks for the replies. This is what i'm trying to mount - a riversmith fly rod rack.
Currently I can't fit in my garage due to the height of the clamp and the factory cross bars. If I can use the T-Track mount that they sell as pictured below I believe I will have the clearance necessary...
Hi.
Does anyone know of t-track crossbars for the factory rack for lc200. I’d like to maintain the low profile of the factory rack and not use the towers that Yakima sells.
Thanks
Eric
Nokian Hakka R5 SUV 275/65/18 just installed here. Snow Belt in Ohio.
Will assume they are at least as good as R3’s which I had in the past. Funny thing is they have “Ultra-Low rolling resistance” stamped on the sidewall. We will see about that 🤣
I haven’t been off road yet however the magnet shown above is really quite strong. Much stronger than most car mounts and the iPad mini is quite small for a tablet.
Downside is the magnet is quite a bit larger than some car mounts,
Setup in this fashion I can use either or both. For example I usually only use my phone for daily driving and leave the iPad in the center console. On longer trips when I need navigation I fire up the iPad.
jefo13 - what is the Engine app you refer to?
Thanks
The peak design mount holds the phone and charges it (since I have the charging version). The ipad mini 6 has great battery life so I don't charge it often. When on a road trip or if my kids are streaming off of the ipad i'll hook it to a cable from the charger that you see below the peak...
Here is a picture of the iPad in position.
When i'm not using it, it fits perfectly in the center console (I don't have the cooler box).
Hope this helps someone. I'm a new owner and have found these forums invaluable.
Enjoy!
I saw a few threads asking for help with less "intrusive" CarPlay setups. I thought I'd share my solution which is not perfect but is an easy and clean install.
Supplies:
2.5 inch black metal hinge
OQTIC Phone Magnet (Amazon)
TUNAI Firefly LDAC Bluetooth Receiver
Car Charger with USB-C as...
Thanks for the replies everyone. Great thoughts. We are getting lots of freezing rain tonight. I’ll see how the KO2’s do on my morning commute in the morning.