dr_dobro

Got it. I bought two new ones not realising I have two from a donor engine as. I will look for the used one and get back to you. Don’t really need the extra pair ! Dan

Hey there everyone. I recently picked up another Fj62 parts rig. It's been sitting since 2017. It's from PA so as you would guess every body panel has some type of rust. The Frame isn't all that great ether. I got it started and the 3fe motor...

Bought this ARP 1HD-T head stud kit from Noordeman (Aus) back in 2020, but due to the backlog I didn't receive them until well after my engine was rebuilt. They are brand new, never been opened. Retail is around $1,000 so save yourself some cash...

40 Ambulance door complete with header in excellent working order. These have been stored for a very long time, they have some standard usage dents. They literally almost no rust except some surface on the underside right under under the rubber...

Hi Sean. Toyota still has the stiffeners new. I bought a pair a few months ago.

Went wheeling with the guys at Yankee Toys Fall Gathering 2026.

Had some tim on Saturday to do Landcruiser work

Freeport, mine is the dark green.

Was just down recently… didn’t see a single cruiser :( … not even Jim … usually see him for a hello but wasn’t around In front of the childhood home :) Btw anybody know of anybody who wants to buy a 1930 Ford Model A … original paint …...

Well that was fun, transmission is out. I havent pulled an automatic in years. Unlike my standard transmissions I didnt have to pull the floor to get it out. The oil was nice and black, definitely smoked the clutches. I pulled it out as one unit...

I decided to tackle the reported fuel smell, I found a loose'ish hose on the fuel separator. Also a pin hole leak in the pump area and lastly the fuel sender also had a leak with 5 psi of air. I bought a smoke machine and tightened the hose that...

Hold my beer, I'm gonna try something.....When I built the truck I used a set of BMW seats, I pulled them after installing the center console. The drivers seat was rubbing against the console, the passenger seat was a little too tall and the seat...

Had a small ATF leak from the A/A Adapter, must be something with the casting that could be a small fissure allowing oil to pass by the bolt threads. I removed the bolt and cleaned the threads and used ATF sealant on the bolt and put it back in...

Went to a car show with both 40’s, no trophies but a great day with a bunch of the local guys. It was a sight to see having so many LCs in one place. Black and white photos are courtesy of Sergey, super cool!

I recently purchased a vehicle off of BAT after seeing many others do the same to varying degree of success and satisfaction. I am a reasonable human, and I understand that my experience is anecdotal and a test group of one. However, I wanted...

Step 3 rebuild 3rd member with new ARB, new gears, new bearings, solid pinion spacer. I think I will install this in the rear axle since my rear bonded seal is leaking, and then fix that and install in the front. I also have a rear vibration at...

New diff/locker step 1: Build a post and mount my new Mark William’s Bench mule This thing is great. Step 2 - get terrible ill the last five days and laid up in bed

Finally starting the reassembly of the front axle on the swb45. The yellow zinc on the ubolts I installed 34 years ago was long faded, so I opted to put on some fresh ones I got from @dr_dobro …in 2013!😛

Looking for either a complete assemble hatch assembly in great condition or a complete mechanism with handle, links etc. Needs to be shipped to NY