Recent content by 80Nomad

Good day gents, is it possible to purchase the rubber feet which are on the air cleaner box separately? The catalogue does not list these apart from the bolts.

Really appreciate such a detailed response Malleus, can continue assembly now, or disassmebly or th interior foot space to check the condition behind and drain of the sunroof..will update how I get along..

As a post is limited to 5 photos I will post separately what I discovered after removing the LH fender. The fender is mounted in two spots on the rear, one is a screw and another fixing is a bolt which connects to the inner fender, am I correct that I should use 90119-06420 M6 x 1.0, 20-mm...

Thanks once again for the heads up! I checked once again on the truck and have couple of questions: As the front has been disassembled numerous times, most of the fasteners are not OEM. For the front and rear flare bolt, currently its a bolt with a washer and nut behind. There is no grommet in...

Thanks alot, I did try to search with my VIN in the catalogues, whilst I mostly find the parts I need these are the ones I cant find.. I do have flares on the fenders, but I dont have the mudflaps, actually the mudflap mounting section has been trimmed down on the flares to allow more space...

Hello colleagues, Im overhauling my front end and would like to use OEM bolts, im unable to find the correct PN's for the bolts inside the fenders. Could someone please assist? Mine is the 95-98 hdft version. Thanks alot.

Great product, although my drivers side bracket cracked on installation. Oh well, epoxied it, just waiting to dry. For the ones who think it will fit with even one tab on, no it wont!

Thanks for the wiring diagram, just what I was looking for as couldn't figure out if the brown wire was +12v or ground. Where would be the best place to ground it?

Hi Gents, I'm in the process fitting a sub tank into an EU spec LC80 (diesel). My truck does not have the (6 pin) connector in the sill harness. Are there any other spare cables I can use? Trying to avoid pulling a new cable. I tried to identify the wires running in the harness, but was unable...

Thanks, its seems that I need the female plug part #90980-11245 and 3 wires (part #82998-12440)

Thanks a bunch, what a great document. Based on your PN I also found another thread to confirm plugs are correct. https://forum.ih8mud.com/threads/fsm-non-us-sub-tank-diagram.140830/

It seems to be 11407

Resurrecting an old thread, had the parts for a while now, didnt have time to do the install on my diesel 80s. Im missing the wiring harness with the triangular female plug 82169-60020 to connect the petrol 3 pin level sensor. Was anyone able to source the PN for it and the pins? I can make up...

I'm currently running 37x12.5r17 BFG MT tyres on -25 offset rims, this is a bit too much as the wheels come out of the fenders slightly. I only have 4 rims (without a spare) and I would like to replace them with r16 rims which are easier to get (set of 5)...now there are not so many tires out...

In the end I was able to find used straps. The ones you show seem to be for the 100 series, but you say they fit without any issues? Thats good to know, thanks.