Recent content by 80hj45

MSC INDUSTRIES sales PTFE-TEFLON film -- would be great for between leaf springs!!!

Found the knuckle balls i was looking for!!! I have even have an extra set, if anyone needs them!!!!

Dude, Thank you but i already found some. I'll update the forum.

Anyone out there have some fj80 knuckle balls, that i could pay you to remove and ship? Need for custom housing project. Must be cut off where i can reuse. Thanks Again!!!

Not really, guess any of these will work.

Sold!! i'm in NM. Wish i could pull just to save you time outta of life. I'll happily pay the extra Bill. not IFS right? let me know how to pay you.

Im interested in the front axle? How much?

Got link to this Adaptor or how to get such a thing?

Is there a master that will do drum in rear but also be able to run discs? when i upgrade

Hey Georg, question about the fj80 master cylinder. I have 1980hj45 with factory front disc. What modifications, if any are needed to make this match?

THANK YOU! Looks like im going to need the luck as much as the money! Ha! I got question. If i was to do this piece at a time H55f first. HAS ANYONE driven a H-diesel with 5-speed??? I got a fresh little motor but under higher rpm its hard to keep off of Hot temp (and keep any freeze...

One last question! I really want to go the right route with this, and keep it all legit Toyota. I could put a Cummings in it with 5speed and call it good, But this truck deserves to be Legit. And its my Daily driver. With that said. Can you set me up with right package? Motor, transmission...

Can you get a 1HZ motor also?

I will be in contact will you! Thank you for your Time!!!! Zac

What would one cost me on an average day?