Recent content by 6545SWB

  1. 6

    Tech Talk: H55F Input Shaft & Bearing Retainer Tech/ID Page

    It is not a 2F, it is mated to an LS3 through advanced adapter bellhousing. It is a centerforce clutch kit
  2. 6

    Tech Talk: H55F Input Shaft & Bearing Retainer Tech/ID Page

    The bearing was seized solid and the groove in the retainer shaft is even all around. I do not think this was spaced incorrectly by my original builder because #1 - he is a real pro, and #2 - when this happened 4 months ago, I replaced the entire clutch kit, clutch release bearing, throwout...
  3. 6

    Tech Talk: H55F Input Shaft & Bearing Retainer Tech/ID Page

    Hi Kurt I have new crate LS3 mated to new H55 via Advanced Adapter bellhousing. Roughly 10k miles. This is a JP Virgo build and (as you would expect from JP) an exceptional and capable rig that has been extremely solid in all aspects. The front retainer bearing collar sheared off, seating...
  4. 6

    Registry FJ45 Registry

    Ha! I wish I had the talent to do this work. All of this work was done by JP Virgo (Clemson Cruiser) at Preservation Land Cruisers. It was a departure from his exceptional concours work, but it is a daily driver and summer beach truck and was designed and built for those purposes. When I...
  5. 6

    Registry FJ45 Registry

    1965 FJ45 SWB FJ45-20174
  6. 6

    permanently installed air compressor(s)

    Thanks b16! You can check out the build thread (not complete yet) at Clemson Cruiser's ih8mud thread: Meet La Cuchara Roja aka "The Red Spoon"
  7. 6

    permanently installed air compressor(s)

    ARB Twin in my 1965 FJ45 SWB. DIY 4-way air up hose attachment gets all 4 34's from 12 PSI to 38 PSI in about 5 minutes. Can also run air tools but I have not used it for that purpose. Thank you JP Virgo at Clemson Cruiser!
Back
Top Bottom