Recent content by 509jaykob

Makes me feel alot better about not worrying about it at the moment. It'll go on the list below rebuilding the alternator lol

I have let it go for about 5 minutes and it didn't shut off. And disconnecting stops it but it continues to run if I plug it back in. But pulling the fuse turns it off and reinserting the fuse doesn't turn it back on. I'm not the most intelligent with electric connections but I think it...

Sounds so simple. Yet I am so bad a tracing wires. Might have to wait til it's warmer or get access to a shop. I have the fan unplugged as there isn't a need for AC for a few more months. Everything I said reminds me of the short on one of my FICM harnesses had on my Duramax. Just took someone...

Hopefully someone had this same problem and I haven't looked deep enough in the forums. But the fan for the AC condenser is running after engine shutoff. In winter. Pulled the plug and was clean and dry. To be safe I cleaned with QD cleaner and used some electric grease. Didn't change anything...

For me

Jayk checking in. Probably can't get together til next month at the earliest

I will PM you later. Little busy with work

Ok. I guess I will change the bearings and see what happens. I figured with them being direct bolt ons it would fall into the OEM range for an alignment. If they still are out after all the work is done I'll get the SPC's. Thanks

I have the generation with the red poly bushings and zerk fittings for the bushings and BJ. Not sure exactly which one that is. And I wanna know if there are any alignment correction options for it. I'm doing the front bearings (hoping it stops my slight left pull) when the parts come in but...

Does anyone have the instructions that came with the arms? My 99 I bought a week ago has them on it but I have no information on these apart from the website. Which doesn't give me much

That is the plan! Gotta do a baseline and get it up in the mountains

Thanks for the club link And yes, that one. Got them down to 6. It runs great for the mileage. Got me back to the wenatchee valley without a problem. Definitely needs some interior love. The rust isn't terrible in my opinion. Mostly surface rust. Couple spots that got a little too deep. Some...

Thank you much @TorchRedTulsan

I'm gonna try to get to that tomorrow. Gonna take it to Schwab's and have them check the regular stuff

Hey all. Purchased a 99 LC with factory center and rear lockers. Has had a bunch of work done to it already. ARB front and rear bumpers. Warn M8000 winch. Slee rock sliders. King Racing shocks. Was wondering who/which company would be good to take her to to do a once over on some of the...