What I have done.
Jack up Cruiser and put jack stands on the frame behind the spring hangers.
Support the axle, remove wheels, etc. Remove u-bolts. Disassemble shackle, remove rear spring pin. Repeat on side 2. Pull out springs. Roll axle out...
I'm looking at this from the cheap seats. But for the life of me I can't figure out how folks toss their money on the other side of the world
for used parts and are shocked and appalled to get very little support with a problem. I just don't get...
Where the truck has lived the majority of it's life and how it was maintained are important items to consider
when buying a vehicle that's +30 years old.
✌️ :beer:
I went the same route you did and was annoyed by the firmness of SOR foam and added height. I later cut the foam down and it did lower it a bit, but found the original seats just uncomfortable. I kept an eye open on CL and found a pair Tacoma...
Why don't you hit pause here and determine just what it is that is wrong with your engine? Definitively determine what the symptoms are beyond a quick glance. Do a complete diagnoses and gain a complete understanding of just what the causes of...
I'd call all the shops in my region and see what they have available. If your not necessarily in a hurry to get this done
I'd pull your motor disassemble, Inventory parts and find a reputable Automotive machines shop to machine the Block...
Sorry to hear your predicament. You may be better off finding a good used running motor that was pulled for a swap, going and picking it up and driving it back
and swap it out yourself. Of course I'm assuming you have a place to do this and the...