We installed the front coil springs at the end of the day.
Trans crossmember was a bolt in and done deal. Same for drivelines, surprising but everything is good to go there.
Cheers
If this bothers you in your build thread just say so and I will remove it.
The Patrol lacked crawler gearing at that time. Was tall too with 16” c/o and portals. If you look close you can see the rear LHS control arm bend and bend back, 2”...
Yes I would, they hook up nice offroad and take a beating.
Most of the wheeling I do here in Idaho is sharp rocks, lots of locker time too. Anything will get beat up doing the same.
Cheers
I should have posted these years ago, but better late than never.
Our sweet black lab "Zoey" and handsome Doberman "Schultz" were an amazing duo.
They went everywhere with us, and we went everywhere in the Land Crusier. 80 series...
A beautiful day in Idaho yesterday.
Didn’t plan to go for a hike, was just out for a drive. Really wish I had took my split board, oh well next time.
Cheers
We have been doing the cut at the same place since the first one I did in 2016.
Only the first one got external fish plates though. For a cleaner look we have had frame rail sections bent up, frame rails are an oddballs size. So we insert an...
Close! Its a far less common Franklin Crane Co Size B made in Franklin PA. I have had it for a few years, bought it from a family friend who was cleaning out stuff from his grandfathers garage over in Ohio. At the time i thought i was being...
Finally got to run Pritchett Canyon this trail is very difficult and technical.
We started with 8 Regs unfortunately, at the first obstacle our trail leader, Justin snapped rear axle on his built 40.
The rest of us went on the run trail without...
So this Cruiser has power windows but no power door locks, so we installed them.
We are also installing keyless entry with a FOB. Those parts will be here next week. 🤙
Cheers