Downey EFI kit, with customized to Downey spec. and rebuilt FJ60 Electronic Distributor. Includes throttle body, very rare Downey "Throttle Body Injection" cast aluminum air cleaner housing with K&N Air Filter, Distributor, Fuel Pump, Wiring Harness, Ignition Coil, Knock Sensor, Temp Sensor, Diagnostic Terminal and Lamp, Speedo Detector, O2 Sensor, Weber/Redline Cable Pedal, Control Computer and a Spare Computer, and Toyota Insulator opened up to the throttle body adapter opening size with M8 studs.
Distributor is modified to Downeys instructions and has been rebuilt with a new Made in Japan Signal Generator, Koyo Shaft Bearing, OE O-Rings, Cap and Rotor. There is an edge of the housing that goes outside of the o-ring chipped off, but it doesn't affect the function at all. These original Toyota "Large Cap" electronic distributors are worth several hundred dollars alone.
Also includes a Man-A-Fre round adapter and a K&N Air Filter for fitting to the later 2F Toyota factory air cleaner housings.
I think the only thing missing is an O2 bung.
If you are installing on a FJ40, you will need the later 2F engine side cover that has the indent to allow the large cap distributor to fit.
A few wires were cut when it was removed but most of the connections are marked, there are about 4 wires that will have to be figured out, but the installation instructions are quite detailed. You will get the 14 page hard copy instructions as well as I can give you a scanned PDF version.
Distributor is modified to Downeys instructions and has been rebuilt with a new Made in Japan Signal Generator, Koyo Shaft Bearing, OE O-Rings, Cap and Rotor. There is an edge of the housing that goes outside of the o-ring chipped off, but it doesn't affect the function at all. These original Toyota "Large Cap" electronic distributors are worth several hundred dollars alone.
Also includes a Man-A-Fre round adapter and a K&N Air Filter for fitting to the later 2F Toyota factory air cleaner housings.
I think the only thing missing is an O2 bung.
If you are installing on a FJ40, you will need the later 2F engine side cover that has the indent to allow the large cap distributor to fit.
A few wires were cut when it was removed but most of the connections are marked, there are about 4 wires that will have to be figured out, but the installation instructions are quite detailed. You will get the 14 page hard copy instructions as well as I can give you a scanned PDF version.
