WTF is this stuff???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 22, 2003
Threads
284
Messages
8,118
Location
Kansastitty
I've got a 2F on an engine stand and I've been cleaning it up with a wire brush and parts cleaner. I took out what I assume is the block drain, driver's side by the #6 cylinder and it was full of some black crap thet I dug out and then blew out. It was thick and looked oily, but was water soluble. When I finally got it cleaned out with compressed air, some of it shot out the water jacket by the #6 cylinder. That thing would never have drained anything.
Do I need to be concerned that it was black? The water jacket, from what I can see is pretty clean and I'd rather not have it boiled or hot tanked if I can avoid it.
My first time to tear this far into an engine, so go easy on me.


Thanks,
Ed
 
probably had a leaky head gasket at one time. Not from the combustion chamber, but rather oil/coolant mixing. Tends to build up sludge right there.

Oh, I would probably have it hot tanked if its hard to get it completely clean cause it will just move more of the deposits from other areas of the lower block caivities to that area again...
 
Thanks for all the replies. It was crusty right at the drain, but the rest of it blew right out. I know I'm going to put rings and bearings in it no matter what, so maybe I'll just get it hot tanked along with the head.

Ed
 
Back
Top Bottom