Would these speakers fit LC100 doors?

[milchvango]

Ive seen these mb quart listed as plug and play for 2016 and up Tacomas, I was wondering if they would fit the lc100. Its doesn't list the LC100 as a fitment but the bolt pattern looks similar to the stock speakers.

TC1-118 7 Inch 2-Way Coaxial Speaker System for Toyota and Lexus Applications | MB Quart

MB Quart TC1-118 7 Toyota® Tuned Audio Package: Coaxial Speaker System that Directly Upgrades Front & Rear Factory Speakers.

mbquart.com

 

[rbrave]

Those look like the right bolt pattern. Easiest way to tell is to go on crutchfields website, and look up aftermarket adapter rings for both vehicles. If they are the same, these should fit.

Speaker depth in both the taco and LC should be close - I think there’s about 2.5” behind the door panel in the LC.

 

[TahoeZ]

You might have to do some work to make them fit as they are slightly larger than stock. Minimal if anything.

 

[milchvango]

Those look like the right bolt pattern. Easiest way to tell is to go on crutchfields website, and look up aftermarket adapter rings for both vehicles. If they are the same, these should fit.

Speaker depth in both the taco and LC should be close - I think there’s about 2.5” behind the door panel in the LC.

OH thats a good idea.! Thank you!

 

[Live to Ski]

note that factory speaker impedance is 2ohm. the op speakers are 4ohm. does it matter....some say yes, some say no.

 

[TahoeZ]

Fine to go less load. 4 ohm puts less strain on amp than 2 ohm but will also result in less power to the speaker because of the lighter load. If changing to 4 ohm make sure to go with a higher-sensitivity speaker. The Focals are a great choice.

 

[Live to Ski]

in my case, the stereo installers put in 4ohm. system seems to work well w/o any noticible degrade.

 

[larryt]

I think that MB Quart set is going to be tough to fit without a custom spacer. With a 6" mounting diameter, it's too big to use the factory spacer/mount, which is about a 5.75" opening and provides over an inch of added mounting depth. Pic #2 measures just under 2" mounting depth to the rolled down glass without the factory mount and the MB Quart set is a little more than 2.1" deep. I can't find the bolt pattern for the MB Quart set online but here are a few measurements of the factory hole spacing in the door if you can.