Wiring Up A 6BT

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

LC_Hamma

The Anti-Leafer
Joined
Nov 11, 2002
Threads
98
Messages
2,656
Location
Dallas, Georgia
Slated for my next buildup, I have this '91 Cummins 6BT. I'm already intimidated by splicing my FJ harness to this 6BT's. I've read on PBB that a guy (5.9CTD) had an '89 & all he needed to do was hookup alt., starter, & battery. That would be great, but what I'm dealin' with is far from a 3 wire hookup. My Q is would it be possible to rip out this harness (I have the wiring diagram for the 6BT) & run the least amount of wiring possible?
 
Last edited:
uhhhh...........sure :D


If it were me, working with the knowledge and skill I have (not much), I would start by pulling unnecessary wires out of the harness on there, rather than pulling the entire harness and starting from scratch. That way you also retain color coding and stock connectors.

My $.02
 
aaaahhhhh....judging by that rat's nest, there are some big ass rats!!! if only i had the motor/tranny setup, it would look great under my piggie's missing hood
 
Back
Top Bottom