Wiring problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 4, 2005
Threads
5
Messages
55
Location
Lakewood, Wa
Website
www.faithwheelers.com
I just pulled the cruiser back into the front yard and am getting ready for some winter wheelin,
but now the lights dont work. no tailights, headlight, blinkers or brake lights. I checked the fuse
and it was blown, replaced it and still doesnt work. What is the best way to start to trouble shoot this problem? Thanks for any info you can give me. :beer: :beer:
 
A test light and ohm meter/ continuity tester would be the best tools to use to diagnose the problem. start at the fuse box, test to see if you have voltage. I would them down load or print off a wring diagram and see which way to go. I might then move to the front of the vehicle.

If the fuse was blown then you've got a short. It could be a number of places. switches, rubbed off insulation etc. These things take time and patience. I like to set my voltmeter to and audiable setting for continuity and start looking for grounded circuts or bad switches. Good luck, you are lucky these things are pretty simple. And I say that as I can't figure out which wires go to my tranny and transfer case!!!! In due time I'll figure it out.
 
I also wanted to say that the dash light never worked and the none of the gauges work also. here is a pic of the aftermarket blinker thing I installed along time ago. I didnt have anything when I bought it. Sorry for the pics size, its the only one I have.

100_0253.jpg
 
When did everything last work, or at least when did the lights last work, and what did you do since them.

You still have the old fuse block by the throttle pedal? If so, take it loose to see if it could be so degraded as to make positive contact with ground behind it. Then go over any and all ground points. Make sure they're all clean, bright, and making good contact to ground.

Old stuff can be wiring nightmares. Think about rewiring the whole truck.
 
Start by disconnecting the battery. Next use a Dremel tool with a small wire brush attachment to clean ALL the fuse holders AND the ends of the fuses themselves. Then clean the battery terminals and most important of all clean all the grounds for the battery, starter, and frame ground.
I see you have no gauges installed. How were the amp gauge wires handled? Did they just twist them together and tape them? Check there to make sure it's still connected.

The fuse panel should have two places where power comes in on the right. One is hot all the time, the other only when the key is on. Start checking for power AFTER doing all the above.
 
A real simple thing to check-have you hit any hard bumps or serious pot holes lately. I have a tricky front right turn signal. If I hit a hard bump, it will shake the old wiring and mess with the ground on that signal. It usually knocks out the whole right side of my truck. Took me two new turn signal relays and 3 weekends to figure it out. If you have nailed some hard bumps, turn the power on and start at the front right corner of your truck and start wiggling wire connections to check your grounds. Hope this helps.
 
Back
Top Bottom