wiring help in ct
- Thread starter donnie12
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Joined
- Sep 16, 2008
- Threads
- 96
- Messages
- 2,930
- Location
- Freensville
- Website
- www.poolpartydeathmachine.com
you may want to pay a visit to 'Mud's 40 section, alot of the cruiser crowd have done TBI and can have pinout diagrams and TBI conversion threads. Unfortunately, here on the 79-95 board, the general consensus is that the 22R/RE is the greatest motor ever ever made, and there's none-too-many SBC swaps here on this particular board.
Here are some links for some great info:
https://forum.ih8mud.com/40-55-series-tech/258285-my-tbi-adventure-so-far.html
https://forum.ih8mud.com/40-55-series-tech/168967-big-gay-2f-build-tech.html
https://forum.ih8mud.com/40-55-series-tech/304976-project-not-going-do-frame-off-frame-off.html
Here are some links for some great info:
https://forum.ih8mud.com/40-55-series-tech/258285-my-tbi-adventure-so-far.html
https://forum.ih8mud.com/40-55-series-tech/168967-big-gay-2f-build-tech.html
https://forum.ih8mud.com/40-55-series-tech/304976-project-not-going-do-frame-off-frame-off.html
my greatest resources have been binderplanet.com and moates.net
However, it is pretty simple once you get into it. If your keeping everything then you need to wire up two relays and plug it all in. An elec. fuel pump is need for TBI. I think mine is Airtex E8094 and it runs just fine.
Another forum (YotaJosh) and I have done a TBI swap onto the 22R motors to make the 22RTBI.
https://forum.ih8mud.com/79-95-toyo...project-20re-junkyard-fuel-injection-tbi.html
Im not extremely familiar with the whole swap, but it should just be taking the GM parts and mounting them somewhere under the hood, wire fuel and ECM relay, and draft your starter wires to the GM starter... Good luck!
However, it is pretty simple once you get into it. If your keeping everything then you need to wire up two relays and plug it all in. An elec. fuel pump is need for TBI. I think mine is Airtex E8094 and it runs just fine.
Another forum (YotaJosh) and I have done a TBI swap onto the 22R motors to make the 22RTBI.
https://forum.ih8mud.com/79-95-toyo...project-20re-junkyard-fuel-injection-tbi.html
Im not extremely familiar with the whole swap, but it should just be taking the GM parts and mounting them somewhere under the hood, wire fuel and ECM relay, and draft your starter wires to the GM starter... Good luck!