Wiring headlights

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2005
Threads
14
Messages
60
I'm in the final stages of a rebuild on a June '72 FJ40. I upgraded the Instrument cluster to a mid-70's version. I have grafted the new harness (w/ circular plug) to the old harness. All guages work fine with upgraded sending units. Question: the Haynes manual does not show a pale-yellow wire coming from the original harness. The wire was connected to the negative poles on the fuel and oil gauges on the original cluster. What is to be done with this pale-yellow wire. Headlights/highbeams, blinkers and instument lights are not operating.
 
"Negative" poles of gauges? You mean the ones that goes to the sender? Fuel sender wire is yellow/red stripe; Oil sender is yellow/black stripe. Yellow is the power feed to the fuel and oil and comes off of the fuses that is stitched by the ignition switch on early instrument panels. Later year gauges used a single blue wire with red stripe to power all the gauges. If it is working I would cap it off and forget about it.

For the headlights etc., did you remember to connect the white wire with blue stripe from the amp meter to the fuse block? This one wire feeds all the different fuses for headlights, turn signals, brake lights etc. It can't be a bulb or ground issue if none of them work.
 
Last edited:
Brake lights, reverse lights and marker lights work. That's why I am focused on the yellow wire. I will try to ground this wire. It cound be related to the headlights via the highbeam indicator and the turn signals vi the turn indicators. Does this make sense?
 
Grounding the yellow will just blow its fuse. White with black stripe is ground wire.

If the brake lights work, then there is power to the fuse block. Headlights and turn signals are on separate fused circuits, so chances are that it is two separate problems. Start at the fuses and on out to the bulbs. Turn on the lights and turn signals and then measure the voltage at points in the circuit working out to the bulbs. Look for the point where the voltage drops to near zero and then you know that there is a bad connection just upstream.

Lotsa times it is a problem with connections in the fuse block itself or in the wire connectors. Second leading candidates are the switches themselves, since they are subject to wear.
 
Pin_Head,

Thanks to you reply. I got my issues worked out. The Y wire was indeed power and mated to the LR wire on the newer harness. This also got the headlights to work...go figure. The turn signals were fixed be cleaning the hazard switch contacts. FYI
 
Back
Top Bottom