Wiring Amp gauge

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 20, 2005
Threads
63
Messages
401
I had a Premier Power welder installed a few months ago and the shop said that due to the new wiring harness being used (because of the new alternator) that the Amp gauge could not be hooked up.

Is that correct or is there some way to connect the gauge to the new wiring harness?

Thanks
 
The potential output of the new alternator is much higher than the stock wiring will take. You could get a new gauge (preferably an "external shunt" type) or yu could modify the existing gauge (increasing the size of the internal shunt 4 fold) and increasing the wire size to match.

I prefer amp meters, but if it was me, I would just get a volt meter or an idiot light to indicate whether the alternator is working.
 
Back
Top Bottom