wiper motor?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 23, 2005
Threads
43
Messages
588
Location
East Vancouver, BC
i'm assuming the windshield wipers have 2 speeds. mine only works on the fastest speed, which absolutely bites when it's just wet out and yer driving behind other vehicles. whenever i pull the knob out to the slow speed it'll MAYBE turn the wipers half way before quitting. is this a wiper motor problem? maybe a good cleaning will do?
 
Remove your switch, give it a good cleaning (I use carb cleaner). Don't open it though. Give it a good drying with compressed air.

Get out your multimeter and check that all switch settings are doing what they are supposed to do.

Next, de-gunk your wiper motor. Take it apart. Take notes or snap a few ref pics while taking it apart. Check your brushes and make sure there is some meat left, check your stator with your meter as well.

Re-lube, put together and bench test. Replace blades, refill washer resivor and you will be good to go. Nice little overhaul. Your wipers will thank you for the attention!
 
Very early wipers are one speed. You should tell us what year.

But yeah, if you have a pull switch then 2 speed is correct, and it is often a corroded switch, or plug, issue.
 
Is your motor top or bottm?
If it is bottom remove the defroster deflectors and clean lube the linkage. Fixed the problem on mine.
If it is top IIRC there is a cable drive, I'd give the cable a good lube.

The fact it trys to move tells me the switch is probably okay.
 
it's a 77, pull type switch. i'll pull it apart and take a good look at the switch, don't think it would be the linkage though cause they FLY when it's on the fast speed. i look like the biggest hoser when it's sprinkling out and my blades are zipping back and forth faster than my engine's turning. if the gunk in the motor is anything special i'll post a pic.
 
finally got around to pulling it all apart, been dealing with ups for the past week or so. turns out the motor just needed some grease. it looked brand spanking new under the cover. looks like the contacts on the motor are gettin pretty thin, i imagine they've got a ways to go before getting a new motor though. pretty glad it was an easy fix.
 
Take care of that motor. Toyota doesn't make the 77 motor any more. They will sell you an 'updated' motor that is a 78 and it won't fit under your cover. :doh:
PITA to find the later model cover, yada,yada,yada.

An ounce of prevention...............
;)
 
i said that straight after i pulled mine apart and regreased it

it caught fire 3 weeks later

luckily larger covers are easy to find in aus
 
Back
Top Bottom