Window sticking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 15, 2003
Threads
69
Messages
890
Location
Ireland; USA (WA,CO, CA, CT), Scotland, London
Website
twitter.com
I have a rear DS window that only 'sticks' on up . Going down is normal.

I've taken apart all the assembly, motor, regreased, cleaned/resprayed (silicion) seal etc..
All looks and works fine but on assembly its back the way it was.
Elec. connectors all look fine.

Any ideas?
 
I have a rear DS window that only 'sticks' on up . Going down is normal.

I've taken apart all the assembly, motor, regreased, cleaned/resprayed (silicion) seal etc..
All looks and works fine but on assembly its back the way it was.
Elec. connectors all look fine.

Any ideas?

mine was the same i changed the runs and now it "runs" good.
 
when u say "the runs" what do u mean?
 
Answer

The runs are what happens sometimes if you eat way to much chili or bad food. But in this case I think he means the runs inside the door. If you pop off your door panel you will see the rubber runs that the windows slide in between. There are quite a few posts on this if you search. Mine does the same thing on the drivers side. I plan on changing them soon. During the summer mine are not bad but during the winter they do not move. You might also try spraying some silicon in them or cleaning them as a temporary fix.
 
The runs are what happens sometimes if you eat way to much chili or bad food. But in this case I think he means the runs inside the door. If you pop off your door panel you will see the rubber runs that the windows slide in between. There are quite a few posts on this if you search. Mine does the same thing on the drivers side. I plan on changing them soon. During the summer mine are not bad but during the winter they do not move. You might also try spraying some silicon in them or cleaning them as a temporary fix.

I like your first definition of runs, but your correct i mean these runs

ToyoDIY.com

68151-60011 DS

you will be amazed with the brittleness of the old rubber and the smoothness of the new. (need i say no pun intended?)
 
awh... I didn't clean those... let me try
 
Cleaned the upper section (not within the door) and no difference.
Methinks it must be the motor that struggles pushing that window back up.
More later...
 
try taking them off and run ur window up and down and see the difference, also clean the sides of the window with some steel wool or some, it becomes rough.


changing motor will make a major difference, but most of the muck and dirt will be wedged inside of the bottom run, mine was brittle and full of crud.

Although i think my passenger side after i cleaned everything is still weak, so a motor will be in order, but the 3 others are all fine.

good luck

Cleaned the upper section (not within the door) and no difference.
Methinks it must be the motor that struggles pushing that window back up.
More later...
 
The Runs tend to be more dirty in the door or lower section. You will need to remove the panel and clean them well. Also, after you can spray some silicone aquaseal spray in the Runs. But you have to make sure that plastic seal under the door panel is on well, as dust can get in ruin your Runs again.

I had to change out the Runs on the PR and DR. I also had to change the regulator and the motor on the DR.:crybaby: But, it "Runs" great now!:)
 
Back
Top Bottom