will this fit

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 20, 2006
Threads
139
Messages
4,041
Location
Pequot Lakes MN
putting in a 1976 2f in my 74 had the 1.5f in it... will my headers and intake fit on the newer 2f?

also if I do this can I just take the smog pump off???? I live in MN and dont need it for anything? do I have to plug any holes in the block?
 
putting in a 1976 2f in my 74 had the 1.5f in it... will my headers and intake fit on the newer 2f?

also if I do this can I just take the smog pump off???? I live in MN and dont need it for anything? do I have to plug any holes in the block?

Yes the intake and header will fit.

I think that the plugs are 3/4 NPT and you can plug them with brass plugs, but some one will chime in.
 
The air rail plugs are 1/4" NPT.

Make sure you use brass so you don't damage your head.


The intake and header will fit fine.
 
Do I just buy the plugs at a hardware store... I was at Toyota last night and they said they dont make plugs?
 
The headers will fit fine.

The F intake manifold in held on w/ 10mm fasteners.
The manifold fasteners in a 2F head are 12mm.
It will be necessary hog out the half holes of the F intake manifold w/ a 12mm or 15/32" drill bit.

It is difficult (impossible?) to plug the air rail w/ a common square head pipe plug. As the plug threads down into the cylinder head, the square head goes below the surface. There is insufficient clearance in the hole to get a socket or wrench on the sq. head.:mad:

Solution: Use allen head plugs, like Toyota does.
Available from Toyota or :grinpimp: TLC Performance. :grinpimp:
 
My ACE hardware also caries the hex head plugs.

Mcmaster carries several different types.

www.mcmaster.com
 
Back
Top Bottom