Will these wheels fit? 17 x 8.5 with offset -31mm

[Fisher23]

Will these wheels fit on the 2016 LC200
Center Bore 110.1
Rim 17 x 8.5
Offset -31mm

If so what max tire size can I run?
With 35 x 12.5 x 17 do I need to modify?

Have the OME 2.5" Lift
Front mud flap was heated molded back.

I currently run 285/70/18 = 34 x 11.5 x 18

 

[Heckraiser]

For 17's, fitment will depend on the shape of the barrel of the wheel, and to a lesser extent, the shape of the spokes (whether there is enough clearance for brake calipers). What wheel brand/model? If they're advertised for a 200, tundra or sequoia, they should fit. If not, it's a crap shoot.

:edit: Are you sure that's a -31mm and not a +31mm offset? If so, that will put them right into your fenders. I sometimes get the +/- confused, so just checking

I'll let the LC guys chime in on 35x12.5 tires. LC's generally do better with narrower tires because of KDSS interference. You may need a KDSS relocation. LC fitment is not my department, lol. Wide tire fitment on the LX is much more forgiving.

 

[Fisher23]

Yes it's -neg -31mm pushing the wheel outward.

Have been looking for a set of these wheels for the LC200 for a while, as they are hard to find. or at least hard to find for me.
"but" these are used a custom setup Hutchison's bead locks.

I don't think they'll hit the KDSS being so outbound, but concerned they may hit the fender or mud flap area.

I'll test fit them in a few weeks, may have to go back to 33's, I'm on 34 now with an offset of +37mm.
So this will push the tire out 2.3 inches outbound.

 

[clrussell]

Will they fit yes.

Will there be modifications required, also yes. Specifically the fender and body mount.

I have 35s on 0 offset and it works well. I’m low lift (2”). Also have cut my cab mount and trimmed the fender.

 

[Heckraiser]

Yes it's -neg -31mm pushing the wheel outward.

Have been looking for a set of these wheels for the LC200 for a while, as they are hard to find. or at least hard to find for me.
"but" these are used a custom setup Hutchison's bead locks.

I don't think they'll hit the KDSS being so outbound, but concerned they may hit the fender or mud flap area.

I'll test fit them in a few weeks, may have to go back to 33's, I'm on 34 now with an offset of +37mm.
So this will push the tire out 2.3 inches outbound.

I'm going to go out on a limb and say you're going to need to cut up both the fenders AND quarters for a -31mm wheel, especially with 35x12.5 tires. That's over an inch further outboard per side than the photo posted above. "Bro-dozer" fitment.

I would put this into the "wont fit" category. Sure, you can technically make them "fit," but do you really intend to chop your bodywork up, or modify bump stops to the point you lose half your suspension travel? Not to mention scrub radius. If you're good with all that, by all means, go for it and post pictures along the way. I think it would be easier to find a wheel with the appropriate offest.

 

[open country]

Absolutely not on the -31 offset, even if they "fit." That's like running a 3.5" spacer on each wheel versus factory.