which Scanner to get???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 22, 2005
Threads
38
Messages
289
Location
Florida
I am going to get an OBDII scanner and would like to know what you guys have tried, what works and what doesn't. Mine is a '95, but the scanner at the auto parts store scans it, and it isn't supposed to scan anything pre-'96. I don' know why my '95 scans with these '96 and newer scanners, but it does. I have looked around on the internet and there a bunch of different scanners out there. I am interested in one that would allow my to monitor the engine while I'm driving, like with a laptop. I would appreciate whatever kind of experience you have on the topic. Thanks.

Best regards,
Wes
 
I have the autoenginuity one that goes with a pc. Last week the connector crapped out after 4 years. I emailed their tech support and they're upgrading me to the newer USB connector for cost.

I'm looking forward to all new options I'll now have. Like speed tracer and rolling dyno.

Check them out at www.autoenginuity.com
 
I bought mine from O'Reily's auto parts about four or five years back for $150. It is a reader only. I'm thinking about buying a full trace diagnostics package. I'm kind of steering towards the autoenginuity package in hopes that it will help me trace down a tricky issue:
https://forum.ih8mud.com/showthread.php?t=142213

The catch? Getting the Toyota/GM/Ford package (I have a GM car too) And the Palm software And the extra serial cable and the cable to adapt out my Garmin 3600 to it... Comes to somewhere in the range of $700. There goes my maintenance budget.
 
Hmmmmmm. Wow, ok, I'll go back over these systems tomorrow and discuss this with the wife. The Autoenginuity thing is dang impressive! Thanks everyone for the replies. You have narrowed my search considerabley! I appreciate this.

Best regards,
Wes
 
Ok, one more question guys. I have decided that I will get either the ProScan or the Autoenginuity scan tool. I have never owned or used a scan tool before, so my question is this: Which one would you recommend as far as ease of use and understandable instructions???

Thanks again for your help!

Best regards,
Wes
 
I've only used the autoenginuity but it's pretty damn easy to use.

Across the top is tabs for different uses and when selected there are pull down menus for available readings to monitor.

I didn't even bother to read the manual and got what I was looking for relatively fast. Typical PC user interface.
 
you may want to read some posts by Gumby, wile the 95 supports pulling and erasing codes via OBDII he says a lot ofthe other diagnostic info is not there.

will work great for your 97 though,
 
Back
Top Bottom