Which head which block

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 12, 2006
Threads
1
Messages
4
My F engine powered Cruiser is tired so she needs to be repowered. I have on the ground two 2F engines and a 3F engine. I have been told that putting the 3F head onto one of the 2F engines will give me the best performance. It is my intention to use the original carb, manifolds, and dizzy. What does anyone think of this arrangement? I will be running a 4sp with 3.70 gears. It is most a winter highway rig.
 
You have a 3F head or a 3FE head? Not quiet the same. What you have probably heard talk about is putting the 3FE head and all of the EFI stuff on a 2F.


Mark...
 
To: e rock, my F engine is a 72. It is very high mileage, something like 350,000. It still starts and runs amazingly well. I wouldn't swap it at this time but I came by a 4sp and a different set of gears, so I wanted to do an engine swap as part of the overal resoration I hope to do.

To: Mark W, I had been told the the head volume was different between the 2F and 3F heads so the compression ratio would go up if I used the 3F head. The 3F head may well be a 3FE as it came out of a fuel injected rig.

I would like what ever engine I build to have higher compression. It wouldn't bother me to have to use high test fuel as in my experience the cost are totally offset by increased fuel mileage. I am open to all ideas, but in general like the idea of sticking with a Toyota straight six over swapping in some other power plant.
Can anyone recommend a publication that would do a good job of detailing what can be done to build up an F series engine to make a dependable highway cruiser.
 
I'm not sure that the 2F intake will work with the 3FE head due to the notch at the top of the intake ports.

You won't find the info you are looking for in any publication aimed specifically at the F series engines. Most of it is just good old fashioned hot rodding stuff though. Searches right here and the LCML archives will be your best bet.

What year models are the 2Fs you have to work with?


Mark...
 
A 74 F (internally oiled) head on a 2f will bump up your compression but you have to make sure they have the right chambers and pistons .Closed chamber goes with flat top pistons open chamber can be used with domed pistons . I think there is some info out there if you do a search.
 
If I was told correctly one of the 2F's came from a 77 while the other came from an 84. I never saw either of the rigs they were taken from. I do know that the 3F had a hole knocked in the pan and an inspection showed one spun rod bearing.

Is there a website somewhere with info on how to identify F series engines?
 
Back
Top Bottom