When rebuilding a distributor...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mace

rock scientist..
Staff member
s-Moderator
Moderator
Joined
Feb 17, 2002
Threads
439
Messages
21,708
Location
Las Vegas
Imagine a 79 Dist, I know that for max fuel economy the Vac advance is a good thing... But honestly, for a preformance application, why not rebuild the dist to only have mechanical advance?

Can it be done? Mark? Jim?

Reason I ask, I canot find a new diaphram for my spare 79 Dist that I want to get recurved. So if it is possible to just delete the vac advance it might be a nice thing


;)
 
vac. adv.

mace for just performance you do not need vacuum adv.. it does not work at full throttle and is almost always used as an economy thing as you said. new zz4s come from the factory (or came) with the wrong vacuum unit so that it caused pinging alite throttle. fix? just disconnect the vac.. it is supposed to be a performance engine after all. jim:beer:
 
So, how hard is it to limit the vac advance? Can a bar be put in the place of the Vac advance unit?
 
Someone has to have thought about this :D
 
Mace said:
Someone has to have thought about this :D

jason, dont they both work together?
even with vacume, you still have the weights inside the dist. dont you?

i should know this :confused:

my dual point mallory has a vac adv. and came with different tension springs for the weights.
 
yes they do work together. and there is no real reason I can't just leave the vac advance hose off. But I was hoping for a bit cleaner setup ;)
 
dist.

mace i am not really sure on a toy dist., maybe you should check with the guru jim. but i thiink you can just gut the vac. adv. parts and block off the hole some how. maybe just chop the little rod that moves the points plate?


jim
 
If you just pull it out and cap off the hole, you can always put a good one in later when you find one.

Options are good.;)

Best

Mark A.

FWIW, Toyota DID build mech-only dizzies for some cruisers. I have a dizzy from a LC firetruck that was designed to run at sustained higher rpms for the PTO water pump. It is a mech-only with a cap over the advancer hole.:cool:
 
I am assuming that the firetruck one was not electronic ;)
 
Do you have a timeing lite that has the dial on the back where you could map out your advance curve? Should be able to play with spring/weight combo and initial timing to come up with a decent curve. Might be interesting to see what you can come up with. Al
 
Back
Top Bottom