Wheels / Rims advice

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 28, 2005
Threads
12
Messages
143
Location
Fort Worth
I am in need of new Wheels and Tires and I want to go with a 16" rim.

What do you guys think of the Cragar Black D Window Wheels, 16 in. x 10 in., 6 x 5.5 in. Bolt Circle, 4 in. Backspace? I want to run a 305/70 or 33x12.50 (actual). I have a lift now but I am not sure how much. The previous owner thought it was a 2" lift.

I was gonna take some measurements and stuff and make sure there will be no problems, but I thought I would ask first and see what the community thinks.

I want the 16" cause I think they are cooler and I intend to go disk all the way around and I beleive this will save me some trouble.

Thanks!
 
You'll need less backspacing. Try the search function. This has been discussed many, many times.
 
You know I did search and I never saw what appeared to be a conclusion on backspacing.

Mostly people speculating on what would work.
 
Yeah but idn't the stock rim like a 7" width or something?

I am going to go with 10" rims. Besides 4" seems to be the least amount of backspacing I can find on a 16x10 rim.

Now I am curious as to the back spacing on my current rims. I would definitely like to make my cruiser wider. If the rims on there are 7" with a 3.5" back space then 16x10 with a 4" back space would make the stance 7" wider correct?
 
Last edited:
I think a 16" with a 33 inch tire is a good choice, just my opinion. The less rubber the easier it is to balance. However, having not enough side wall can be bad too. I'm also looking into buy some wheels for mine. I'm looking at 17 inch wheels with 35 inch tires. And yes 3.5 is factory spec. Talk to the wheel people and let them know that 3.5 is factory spec. but you are going with a taller wheel and see what kind of answer they give you. Sorry not much help.:)
 
My math says 5" wider. (2 X 6") - (2 X 3.5") = 5"

Unless you're counting your proposed tire width too; then you'd be 7.5" wider than the stock rim width, assuming you've got 7" wide stock rims.

FYI -- I think stock rims are 5.5" on the FJ40. Mine are.
 
Looks like I carried a 4 where I should have divided by 0. 5" is right.

I searched again and found a million posts on this very same subject. Imagine that :)

Anyway I still never saw anything that was very concrete. I am going to go to 4wheel parts in Dallas and talk to them about it. They'll probably know for sure and I can get my wheels from them at the same time.

By the way. I looked at my current wheels and they are 15x8 Rims with a 4" offset and they clear the TRE by almost an inch. Also steering seems to make very little if any difference on the distance from the rim to the TRE.

I did notice that part of the steering junk might be a problem on a bigger wheel that is in closer.

I have always been leary of wheel spacers, but I may go this route. Marlin seems to come up a lot.
 
Back
Top Bottom