Wheeling ? 3

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 6, 2004
Threads
234
Messages
4,449
Location
Bozeman, MT
When going up steep hills the cruiser would start the die like maybe it wasnt getting enough fuel and so it would still be going up the hill just fine but would end up cutting off and Id be stuck. Do you think I just need to get more fuel to it like with an electric pump or is there something else to look at?
 
my old 2f would get flooded on steep hills and die. probably from floats getting stuck. the key is to just lay into the skinny pedal and crank until it starts and reves than just take off and keep your foot down. at 7000ft it lets out some nice black and blue smoke.
 
I get the same problem with my weber carb. I have to keep the revs up or else it sputters and dies. If it dies on a hill and I have to start it up again I just push the gas pedal down until it fires up and clear it out and try again. I also run an elecric fuel pump. It can be frustrating.
 
it's likely the vent tube for the bowls is allowing fuel to effectively pour directly down the throat once you hit steep sections...pretty common

extend the vents higher, either with a section of fuel line or with a small OD tube gently tapped into the opening....when I ran a Rochester on my V8's, I extended mine til they were just shy of the top of the air cleaner. Also, if you choose to open 'er up, drop the float just a hair.

4bl Rochester Q-jets are the best V8 offroad carb out there, and cheap....can't see why the 2bl ones couldn't be tweaked either....
 
Back
Top Bottom