whats involved-tranny

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 19, 2004
Threads
20
Messages
39
Location
ga
swapping out 3spd tranny,in a73 fj40 with a4spd tranny from 78 fj40,i want to keep my 3spd transfer,what all is involved as far as mods that need to be done to make this swap and how much should i expect to pay for additional parts needed to do this. any info a big help ..i need to let the guy with 4spd know something in 24hrs...
 
I got a new shaft from Advanced Adapters (spelling?) I think it ran about $120 IIRC, I think they give you a couple of different option, try there web sight. I really like my gear ratio in low low and the spacing inbetween the gears with the four speed.

I'm not sure of the differnce in the ratio in the 3sp tc and the 4sd tc but low range is lower with the older tc.
 
Just get the 4sp transfer case too. It's not worth the effort and expense to use the 3sp case for a 16% reduction in low range. You need everything from the bellhousing to the drive shafts. You can keep the 3sp clutch and flywheel.
 
To mate a 3 speed transfer to a 4 speed tranny requires the following parts:
transition gear
Datsun B210 bearing, or equivalent (available at any bearing supplier)
complete 4 speed transfer case shift linkages, including the fork assembly on the front extension housing (the shaft is about 1" longer)

I'd also get the gasket and seal set from Toyota or another supplier and replace all the seals while it is apart.

You'll also need either the spacer from the 4 speed case or a PTO gear for a 4 speed case (3 speed transfer cases usually had the gear and 4 speed cases usually had a spacer).
 
Back
Top Bottom