What's an adequate compression for 75-2F

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2005
Threads
88
Messages
929
Location
Northern California
Website
www.facebook.com
Hello, just had the motor compression checked by a shop today. He said i had one cylinder at 95psi while the others were all around 105psi. He(my mechanic) wasn't all that thrilled with these pressures.I'm also getting alot of oil from the hose that attaches to the valve cover and goes to the aircleaner(carb looked like someone melted a Hershey bar in it.So i rebuilt it) This then makes it's way to the carb.He feels it rings, coupled with possibly some valve guides.He's going to retork the head bolts and adjust valve tappits. Am i in trouble with these pressures or should i just runit? Thanks guys for the help in advance.
 
Sounds like you've got a mechanic's good advice.

You can run it if you want. Does your state have something called terminal emitter? Do you have a Smokey the Bear hat?

Maybe you can get a job in mosquito abatement down in Mississippi next summer.
 
That kinda cranking pressure and blowby means that the engine is pretty bad off.

Toyota says that anything over 113 is acceptable. You don't even have that. I consider anything lower than 120 unacceptable myself.


It's time for a rebuild.

Mark...
 
adjust the valves, was the test warm engine? actually the #'s are all within 10% of each other just low.
 
10 percent rule does not really mean chit with it pumping oil like he stated...



Time for some new parts.


Good luck!


-Steve
 
3_puppies said:
adjust the valves, was the test warm engine? actually the #'s are all within 10% of each other just low.


If they were all 50psi, they'd all be within 10%... ;)


Mark...
 
Back
Top Bottom