Was the firewall originally "undercoated?"

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 2, 2004
Threads
45
Messages
307
Location
Denver Colorado
Just as the title states, I am in the middle of a frame off restoration, I am blasting the tub today and my firewall and lower areas around the transmission hump have a greezy undercoating type substance (like roofing tar) that even the sand blaster can't get off!

Was this from the factory? And reguardless of its origin how the heck can I get it off easily?
 
Yep, OEM tar...
Cold you can chisel it in chunks without scratching the metal with a wood chisel, then use mineral spirits or kero to get it all off.

Warm, you can scrape it off with a putty knife. Plain and simple it sucks to remove.


no easy way to do it
 
depends on the year if the floor had tar or not, early 40's up into at least the early 70's had a bare floor. I almost think the tar didn't show up untill 79 when a cat was added but I do think that it was earlier than that, like maybe 75
 
tobydog said:
My 74 has it. Mines still good, leaving it in after hearing all the pain it is to get off.

My 76 had it.

I used a propane plumbers torch to heat it up, and a putty knife to remove it. Took all of 10 minutes. Came off all in one piece. I made quick work of what was left with some acetone. I ZeroRust coated the tub (works well, but it doesn't hold up to brake fluid very well) with a plan to herculine later. Well..... 1 year later still not lined.

I will probably durabak it at some point
 
Problem with the Tar as you call it was it hardened and allowed water under it overtime, I prefer to remove it and use other sound deadeners. I think it is not a tar, rather a sound deadener that was glued to the floor, simular to sound deadeners.

All original body sealers should be removed during restoration, the old stuff is brittle and not longer provides the sealent you want.

I have learned products like Heavey Duty Drip Seal and 3M heavey body sealer are good products to apply over the seams. I also like to gauge out the old and brush in a rust creeper to chase the capiliaries and push out the moisture prior to sealing.
 
Radd Cruisers said:
Problem with the Tar as you call it was it hardened and allowed water under it overtime, I prefer to remove it and use other sound deadeners. I think it is not a tar, rather a sound deadener that was glued to the floor, simular to sound deadeners.

All original body sealers should be removed during restoration, the old stuff is brittle and not longer provides the sealent you want.

I have learned products like Heavey Duty Drip Seal and 3M heavey body sealer are good products to apply over the seams. I also like to gauge out the old and brush in a rust creeper to chase the capiliaries and push out the moisture prior to sealing.


I completely agree, anything that creates a moisture barrier between the tub is unaccepatable. It would be one thing if these 40's were galvanized, however we are not that lucky. I just yesterday purchased 3M sealer, it's one of my last steps, hopefully this weeked before I place the repaired tub back on the completed frame.
 
Back
Top Bottom