Voltage Reading

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2006
Threads
9
Messages
55
Location
Portola C.A.
My 73' 40 died last weekend, so I took out the alt. and battery and had napa test them. Battery said it was low and just needed a charge, alt. said low output. So I got a new alt. and have driven it all week with no problems. Tonight I drove it wit the lights and heater on and the voltage goes all the way down to 11-12 at idle. When you get going again it shoots up to 14-14.5. The lights get very dim at idle. How much tolerance is ok. Oh yea it's got a 78' 350. I assume that the alt. is internally regulated since I couldn't find a regulator any where else. Thanks
 
Install a larger diameter alt. pulley and increase idle r.p.m.s a bit :cool:
 
It is fairly normal for older models of alternators from the 70s to early 80s.

Will going to a newer style alt with an internal regulator give more constant voltage?
 
The pulley might do it but it could also be the way the alternator is wired. If it's the three wire gm alternator, one of the wires is the voltage sensor wire. If this is too close to the output of the alternator it may not be reading correctly. You could try rerouting it somewhere else.
 
When I bought the alt. I carfully looked at every thing but the diamater of the pulley (go figure) I haven't really got to dig into the wires yet. Previous owner installed a new harness and did an sh*tty job. I have A love hate relationship with my cruiser but I can't imagine not owning the thing!!!!! Thanks guys
 
Back
Top Bottom