Video: Am I reading these codes right?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 22, 2015
Threads
1
Messages
21
Location
Anchorage, AK
Video:

Looks like maybe crank angle sensor and oxygen sensors.

It's a 91 with a 3fe, 206k, all stock. Runs great minus the codes being thrown.

Thanks a lot folks.

Jay in Alaska
 
I saw a 12, 25, 26. No crank position sensor on a 3FE. From the FSM:

EFICodes1.webp


What is the history? More info required.
 
Thanks for the reply. 12, 25, 26 is what i thought too. My assumption with that rpm signal was a Crank position sensor but I see now it doesn't have one. I just picked this up on Sunday and it had no check engine lights , I figured after a few days it would come on because it seems everybody resets them before before they sell stuff. I looked up the codes last night and the possible causes were more narrowed down in the Haynes manual. With that list you posted it seems it could be a lot of things.

Any common cures for 12, 25, 26?

Thanks!
 
12 could be a faulty connection at the distributor or the field coils need to be adjusted in the distributor housing. If the ECU wasn't getting the correct pulses there would be no spark, so it's only happening at cranking rpm and for a very brief time.
25 and 26 may be related to the AFM if the previous owner had a go at the internals either through the top or by removing the 2 Phillips screws and yanking the guts out. Make sure the internal air flap moves freely and easily in both directions throughout its range.
If the O2 sensors are old then they are suspect as well, but this could be a combination of things.

Do you have a maintenance history on the vehicle?

Pull the 15 amp EFI fuse in the underhood fusebox on the left fender for 5 minutes or so. That will clear any pre-existing fault codes and allow the ECU to relearn parameters. This will also keep you from chasing your tail.
 
The ECU relies on feedback to trim A/F ratio. Primarily the O2 sensors, the AFM (which contains an air flow meter flap and intake temperature sensor), TPS and speed sensor. 25 and 26 means it can't regulate A/F ratio properly. I would run through the FSM tests for the AFM and TPS and replace the O2 sensors and inspect the wiring for all sensors.
Possibly a leaking injector as well. Start with the sensor tests first.

Remember to clear the codes after you do anything. 1986 technology.
 
I did reset the light by removing the 15A fuse so i'll make sure to do that after whatever I replace too. I don't have an FSM but would it be smart to just replace all O2 sensors. Would the tests on these sort of primitive EFI setups be able to tell which O2 needs replacing?

The maf looks like its been worked on and then resealed with some blue sealant. Limited maintenance history with this thing but it is running great so far. Beside the dented front bumper, its pretty darn clean too. The pan is my wife's semi daily driver for a year then it's just a dedicated camp rig.

Thanks for the help!

image_zpsef84f926.jpg


Down by the Turnagain Arm, north of Girdwood, AK:

image_zpsd635779e.jpg
 
The AFM has definitely been opened up so that would be my first suspect. Any 3FE AFM will work from an FJ62 to FJ80, so I would find a used one.
O2 sensors have a limited lifespan and may or may not throw a code even if they are out of spec. Best practice is to replace both of them if you're not sure of the history. They are no longer available from Toyota for the 3FE so try to find Denso replacements.
That engine bay looks too clean ;)
 
Alright, I'll start with the o2 sensors and I'll look around for a refurbished maf. I feel like any used one up here will just have some similar issue anyway.

Thanks for the help and yes the engine bay is too clean. Once it's running with no codes then we will take it to the mountains and play.
 
Interesting morning, I decide to go up a mild trail that climbs about 3000 ft here north of Anchorage. Around 1000ft approximately , my check engine light goes off. To me that suggests something to do with altitude compensation (maf) or it could just be a fluke. Driving around a little more back down at sea level and it hasn't come back on yet.

The o2 sensors are being shipped and I'm sure they need replacement anyway but that is making me wonder about this maf for sure.
 
Just to clarify what jonheld said. You dont have a maf. The 3fe has an afm. You could try cruiseryard. Look him up on here, great guy
 
Just to clarify what jonheld said. You dont have a maf. The 3fe has an afm. You could try cruiseryard. Look him up on here, great guy

Right , well I know where it is and generally what it does. ha! Im just so used to calling them one thing. Just curious, do these trucks have altitude compensation somehow like the newer sensors? I'm wondering if my climb today is related to the light going on temporarily.

Thanks
 
Im sure the altitude will effect how it runs but no sensors for it specifically. The altitude might have leaned it out and effected the o2 sensors
 
Ok,I know even my early 90s Mitsubishis had a a mass airflow sensor and it did compensate for altitude. I'm not familiar with the guts of these afms yet.

Thanks for the help though guys
 
Back
Top Bottom