Vibration???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 20, 2006
Threads
197
Messages
4,672
Location
TN
I need some advice.
Tonight I was driving around and got a vibration in my cruiser.:crybaby: It was running smooth then after about ten miles vibration that gradually got worse and I had to pull over because the whole cruiser was shaking. It felt like it was coming from the rear somewhere. I thought it might be a flat so I got out and looked around but there was nothing. So I got back in and started driving. Smooth for about a half mile then it gradually got bad again so I pulled over again. Didnt see anything wrong. I jumped back in and did some figure 8's in a parking lot with no problems and then kept driving. No more problems yet. And no prior problems.

What could it be?

I did the CDL switch pin 7 mod yesterday. Could that have anything to do with it. I tested everything yesterday and everything engaged and disengaged perfectly.

Thanks

ERG80
 
Are you sure it was coming from the rear?

I was having similar issues but for me, it seemed to be coming from the front. I did a complete front axel rebuild including new rotors and the problem went away.

Still not exactly sure what the problem was. It could have been one of these:

Had 100 series pads on bad rotors. :o

The spindle bushing was dry. :doh:

Thrust washer had a broken tab and I think the hub nuts had been rotating :eek:

or something else.
 
Not positive it was coming from the rear. It felt that way and sounded like it. I drove home about 10 miles and it was running smooth as glass. It was just those two times and no more problems.

I dont have 100 pads and I had a the toyota dealership in town check it out a few months ago and it checked out perfectly. Fluids that needed changing were x-fer and diffs and thats all.

Any other opinions?

ERG80
 
Last edited:
Driveshafts? U-Joints? Maybe try putting some grease in the fittings? I'm dealing with a similar problem, so if you find a solution, post up!!!!
-TT
 
My first thought was U-joints, but I wouldn't think the vibration would be intermittent. The viscuous coupler might be a place to look, but that's a pretty wild guess. All same-size tires?

-Spike
 
I thought about the u-joints but i looked underneath the cruiser and wiggle the drive shafts and all was tight. I will try to grease them.

The tires all match.

If it was any of those things why would the vibration get bad with no prior problems. And be gone after I stop?
Thanks for the posts.

ERG80
 
This may sound stupid but did you have your emergency brake on.
 
I've had 'tight' u-joints that were junk. They don't get loose enough to feel by hand until they're ready to fall out of the truck.

-Spike
 
I've had 'tight' u-joints that were junk. They don't get loose enough to feel by hand until they're ready to fall out of the truck.

-Spike
that would vibrate all the time wouldnt it? not just for a minute and then go away?Thanks ERG80
 
Yes, in my experience they would vibrate under specific conditions, for instance when a u-joint went bad on my 4Runner it began to vibrate only on deceleration in gear- but it would do it every time I decelerated in gear. A bad u-joint will most likely do the same thing all the time, gradually getting worse.

I just had a thought, I wonder if your brakes are acting up. I've heard of calipers sticking and causing vibrations, and that might come and go at random.

-Spike
 
Yes, in my experience they would vibrate under specific conditions, for instance when a u-joint went bad on my 4Runner it began to vibrate only on deceleration in gear- but it would do it every time I decelerated in gear. A bad u-joint will most likely do the same thing all the time, gradually getting worse.

I just had a thought, I wonder if your brakes are acting up. I've heard of calipers sticking and causing vibrations, and that might come and go at random.

-Spike

thats something I didnt think of. brakes are new but that is a good idea.
 
I don't think the brakes would cause vibration while driving--it would occur when you hit the brakes. Replacing pads would not fix this; it's the rotors.

Another thought it your wheel bearings...does this happen at all speeds, or just when you get to a certain speed? Does it get worse in certain circumstances? Does it happen when you're braking? Any other clues as to when it's occurring?
 
I don't think the brakes would cause vibration while driving--it would occur when you hit the brakes. Replacing pads would not fix this; it's the rotors.

Another thought it your wheel bearings...does this happen at all speeds, or just when you get to a certain speed? Does it get worse in certain circumstances? Does it happen when you're braking? Any other clues as to when it's occurring?

I was driving about 45mph. it was smooth and then started getting worse so i slowed down and pulled over. I Looked around to see if it was anything obvious and didnt see anything so I drove off. After about 3/4 of a mile it started shaking again and I pulled over and did figure 8's to try to hear anything funny. I didnt hear anything so I kept driving and It has been running fine for a few days.
 
I don't think the brakes would cause vibration while driving--it would occur when you hit the brakes. Replacing pads would not fix this; it's the rotors.

Under normal circumstances, no. If the calipers are sticking, then the pads might be chattering against the rotors without putting any pressure on the brake system. Rebuilding the calipers is a fairly easy job.

I'm almost positive I've read of other people on this board having this problem. A search for 'calipers' or 'sticking caliper' might turn something up.

-Spike
 
If you havent already checked, I would do the wheel bearing test:idea:

But also agree could be bad uni's but doubt its brakes if you werent braking when this happens...
 
vibrations

Hey ERG80, I have the same problem.

my 96 landcruiser would not shift out of park, so i pryed up the shift overide cover and tried to use a screwdriver to overide the shift (just like tha manual showed) and something broke. Had it towed to mechanic. they claim to have replaced a module and several blown fuses. That was Thursday, Now when i get up to 40 miles per hour it starts to vibrate so bad that i have to pull over. It feels like it is coming from the rear right side. It is intermittent and didn't do it when i went back to the mechanic Friday afternoon. Saturday It did it so bad that i limped to mechanics lot and left it.

The only other thing is that when i had it towed, my wife said they put it on a dolly and towed it backwards!! I'm no mechanic but I would would be a lot less suspicious of them doing the damage had they put it on a flat bed tow truck.

In the mechanics parking lot I drove slowly in a straight line and swear it was weaving irregularly.

Anybody have any thoughts, other than find a new mechanic??
 
Last edited:
Damn that sucks jadaddy. I dont think it's a good idea to tow an AWD 80 without removing the driveshafts because it damages the VC. Maybe towing backwards is different. I dont know.

Im still trying to figure out why mine was shaking. It has been behaving lately.
 
I had the drive shaft out last Wednesday and the u joints all seemed fine. But the vibes came back tonight and I jumped out while the truck was slowly moving and heard the noise coming from what sounded like the diff. crunch crunch crunch. What would that be?
 
Back
Top Bottom