I need new valve guide seals on my 80, burns oil like a s.o.b. Yes, everything else checks out just fine.
Is 180 labor and about 190 for parts a good deal to get this replaced?
I'd get the parts from Toyota to ensure a mechanic's not getting parts "as good as Toyota" "from the same supplier Toyota uses" etc. That seems like a good price, cause its hours of work just to get to the twin cams, then remove them and the valve springs, hold the valves up with air pressure while swapping the seals, etc. I honestly can't see someone pulling this off for that money. Heck, you're so close to pulling the head off at that point why not pull it and have a proper valve job done, then slap a new gasket down and reinstall? I think I paid $300 for a full valve job at a shop when I dropped it off (3 way grind, install Toyota seals, mill head, etc) Just a gasket atop that would be around $200 more in a valve grind kit from Cdan that includes the new valve seals.
Back to your question, that seems extremely low. So low that the mechanic will realize he's been had halfway through and be one unhappy dude. He does know your engine's a twincam, right???
Please keep us informed about this, if the mechanic can do the job (and do it right ) for that price I would be interested in giving him a try. That seems awful low though, I have been pricing some basic maintenance from various shops in the area and they tend to like there pricing (e.g., $66+/hr.). My .02
I am open to that, I plan on doing a majority of the maintenance but may need a source for when I am deployed or in over my head. Shoot me a PM if he is open to doing side jobs. I live in Lakewood but could always drive down for the afternoon.