valve adjust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 9, 2008
Threads
1
Messages
3
i am going to be attempting to adjust the valves on my 1991 fj80 with the 3FE inline six and had a couple of questions. my first is where the hell are the timing marks to line it up at tdc? i bought a chiltons but thats about as helpful as a pile of s***. it says there at the back of the engine, but i can't see them anywhere. usually there is a rubber plug that you remove, at least that's been my experience. i feel like an idiot considering i work for a honda dealership and am ase master certified, but i've never worked on anything but honda's (at least no major work) but none the less i still feel like an idiot. I would greatly appreciate any help at all in this seeings how most of you are fairly familiar with the landcruisers ( as I will be with enough work on this one). my other question is how hard is the valve cover to remove? it doesn't look too bad, but i read a thread in here of a guy having trouble removing it, and i would hate it taking so long that i would have to put it back on and warm it up again to adjust the valves.
 
Just above the starter their is a plate that you remove to see the timing mark behind. It is always better to get the OEM FSM. Way better to work from.
Later Robbie
 
Check the 60 forum, there's lots of threads and advice there on the 3FE.
 
Valve adjustment on the 3FE is the same as for a 2F if you need to track down more info. The valve cover is a little tricky because it tends to hang on the rear of the rocker arm assembly. Once the 4 nuts are off lift and tilt the cover toward the passenger side but also angle up the front of the cover to help clear the rear of the rocker assembly. Getting it reinstalled and keeping the valve cover gasket in place is more of a trick than removing it.

Don't sweat having it good and hot with this first valve adjustment. Think of this as more of a practice run to get comfortable with the process.

And once you've located the timing marks put a dab of white paint on them so that they'll be easier to see when you set the timing.
 
Back
Top Bottom