Vacuum assisted brake question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 17, 2019
Threads
16
Messages
81
Location
75455
Im trying to figure out if i have an issue or not with my master cylinder. With the engine off, i can pump my brake pedal a couple of times and its its rock hard and stays there. With the engine running it pumps up and gets pretty hard but if i push a little harder it goes down a couple of inches. Pedal feel is good not mushy and ive never had it go to the floor or roll when holding the brake. Normal driving it seems fine but id rather not just have it not work all of the sudden. Is this just the vacuum booster working? Ive never really tried this on any other car ive had, most were manual brakes on old trucks.
 
So when the head gasket starts to leak, the residual vacuum in the cylinder head gets drawn into the PCV via the EGR regulator. Can be the VSV or PHH but less common on PAIR equipped rigs (with or without ABS.) Common on Toyotas of this vintage.

Your brakes won't give out on you but it's likely you have a head gasket that's about to go.
 
So basically im losing vacuum because of the head gasket and im dropping vacuum from my booster?
 
not sure about the headgasket issue...
but would it make sense that you get a little extra pedal push because your vacuum source (engine) is actively drawing vacuum? so you max deflection is just a little more than when you have a static reservoir (engine stopped).
 
So basically im losing vacuum because of the head gasket and im dropping vacuum from my booster?
Nah. Just kidding. Sounds normal.
 
Back
Top Bottom