update on Orion ( for tree )

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 20, 2004
Threads
129
Messages
6,697
Location
here
Oil changed second time after more road time and found exactly what you found and some flakes that were larger than I would of been comfortable with but no operational probs other than still slips out high 2 into nuet. when letting off gas in third gear on tranny. Will be pulling t-case to inspect shift collar , fork , and just look to see if all else is tight. If it looks o.k. then we are gonna crank the tension screw down on the shift fork and stuff it back in.
But it seems to be normal to get the silver paint out the first time.
 
thank you for the update. I am going to drain the oil for the second time here shortly. I didn't have any problems on the snow run and the transfer case is getting quieter.
 
just an fyi , I put the disc e-brake from Man a Fre on and my freeway driveline vibration got much quieter . I am now suspicious that the drum for e-brake wildly exentuates any driveline slop. I was seriously thinking we had f-ed the t-case up but good to know the rattling noise was somewhat reduced with the e-brake disc conversion.
 
I am still having problems slipping out of high or low. New spring tightened past the cotter pin. I will also re pull and replace collar. I wonder how many of these are out there running without problems? Has the new collar fixed this for any one?. With the ball as tight as I have it the something is forcing the collar off the drive gear. I just do not think a newe collar will fix this. I never had this problem with the stock case.
Chris
 
pay carewful attention when setting shift fork , not just worn parts but be sure that the fork is holding the collar in correct position when in detent. I had the lock tab reversed and it caused the fork to rub the high gear dogteeth when t-case was in nuetral .I agree with others that the wear inside the collar causes this , I had similar problems with my 420 popping outa third and replacing the collar and gear to get new dogteeth fixed it so it should follow that the orion has same issue when new dogteeth run in worn collar .
 
If you can't quite picture the fork issue peesalot is referring to, nuclearlemon has some good photos on her recent thread about replacing the fork and collar.
 
Back
Top Bottom