Twin ARB compressor bracket in engine bay

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 30, 2012
Threads
39
Messages
233
Location
Santa Cruz, CA
Got a twin ARB Compressor for the FJ40. Had a local fabrication shop make a bracket for the engine bay (hopefully its not too hot in there for it) and should be done wiring the thing up this weekend.

At the same time had him weld on some clevis recovery points on the front bumper. He did a great job. If you are on the Central Coast of California (Santa Cruz / Monterey area) I would highly recommend him.

I will post up some photos of the ARB once everything is up and running but this is a good start.

The front bumper is an air tank for the ARB compressor.

bracket 1.webp


bracket 2.webp


clevis 1.webp


clevis 2.webp


ARB engine 1.webp
 
Got the compressor all wired up this weekend. works like a charm. I have a very slow leak I have to track down somewhere in the system as it sits with pressure it does drain ever so slightly. I have the compressor on the passenger side behind the battery. From the compressor is a water separator to remove water then it goes to the front bumper that is the tank. Does not hold that much but enough. From there I have a block that holds another outlet, a blow off valve and a PSI gauge. Then on the bottom of the block there is a line that runs to the rear of the vehicle. All in all I really like the way it turned out. I may run the air filters into the cab, but we will see how this works initially.
link to youtube video
 
Looks awesome!

Any update on performance? Does it get too hot in the engine bay?
 
Back
Top Bottom