TurnKey Engine Supply

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 17, 2006
Threads
2
Messages
3
Hello All,

Just wondering if anyone has had any experience with TurnKey Engine Supply? I'm going to do a vortec install on my 79 FJ/VJ 40. Their website says something like "5 wire install, run fuel lines and you're in business." That's about my speed. I can do the fab work but when it comes to flashing a vortec computer and building a wiring harness I'm at a loss. Thanks for the help.

ROB.
 
Hi Scott,

Did you go with the 5.3 or the 5.7 vortec? And are the installation instructions as easy as they say? I'll be running a GM bellhousing to a Marlin built SM465 tranny to an Orion transfer case. Thanks for your help.

ROB.
 
Turnkey engines are easy to install, but more expensive.

If I were to do a 350 vortec engine conversion, I'd find a low mileage pullout and install it using the factory harness or you could buy an aftermarket harness from www.painlesswiring.com. Their harnesses are easy and labled. Just be sure to get the ECM that comes with the engine.

Jack Rick has a good write up on his install.

Look here under, "Chevy Engines"

http://www.ih8mud.com/cruisertech.php
 
Back
Top Bottom